NEMIX RAM 32GB (2x16GB) DDR5 5600MHz CL46 1.1V 288-pin UDIMM Supermicro X14SAZ-TLN4F memory upgrade
- 32GB (2 x 16GB)
- 288-Pin DDR5 UDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
NEMIX RAM
32 GB DDR5 5600 CL46 UDIMM kit verified for Supermicro X14SAE-F motherboard
Size 32GB
This 32 GB DDR5-5600 UDIMM delivers the precise 2Rx8 rank, 1.1 V voltage and CL46 timing the motherboard expects. Non-ECC unbuffered design matches the board's 288-pin slots so the system recognises full capacity at rated speed without manual tuning.
Operating at 1.10 V means the modules run cool and draw minimal power during typical desktop workloads. No heat spreader is fitted, relying on case airflow, and the low voltage helps keep acoustic levels unchanged in a quiet build.
The jump is worthwhile when your current memory runs below 5600 MT/s or totals less than 32 GB and the board's population rules allow this 2Rx8 configuration. Buyers needing ECC, registered DIMMs or higher frequencies should look elsewhere.
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM Original Series Memory |
| Model | DDR5 Non-ECC Unbuffered UDIMM Memory |
| Part Number | MD44800-328K1 |
| Capacity | 32GB |
| Type | 288-Pin DDR5 UDIMM |
| Speed | DDR5 5600 (PC5 44800) |
| CAS Latency | CL46 |
| Voltage | 1.10V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Heat Spreader | No |
| Compatible System | Supermicro |
| Features | DDR5 Non-ECC Unbuffered UDIMM Motherboard Compatible |
| Package Content | 32GB DDR5 5600MHz PC5-44800 2Rx8 1.1V 288-PIN Non-ECC UDIMM KIT |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
Align the notch on the module with the slot key, press firmly until both retention clips click, then check the motherboard manual for the correct DIMM population order so the 32 GB kit is recognised at 5600 MT/s.
No routine maintenance is required; the module has no heat spreader and runs at standard JEDEC voltage, so replacement is only necessary if a memory test reports errors or you increase total system capacity beyond the board's supported limit.
The CAS latency of 46 cycles at 5600 MT/s sets the baseline response time; under continuous heavy workloads the memory controller's thermal throttling or the board's maximum supported rank count will limit performance before the modules themselves do.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?