We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green printed circuit board with black memory chips and gold edge connector, no heat spreader

NEMIX RAM

NEMIX RAM MD44800-328K1 32GB DDR5 5600 CL46 2Rx8 1.1V UDIMM memory upgrade

SKU CH-SXSD-434J3

32 GB DDR5 5600 CL46 UDIMM kit verified for Supermicro X14SAE-F motherboard

  • Capacity32GB
  • Type288-Pin DDR5 UDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCNo

Size 32GB

  • 32 GB capacity doubles memory headroom for demanding workloads
  • DDR5 5600 speed delivers high bandwidth at rated frequency
  • CL46 latency with 1.1 V operation matches controller expectations
  • 2Rx8 288-pin UDIMM form factor fits Supermicro X14SAE-F motherboard
  • Built with major OEM chips for tested stability

Exact-match DDR5 upgrade for Supermicro X14SAE-F

This 32 GB DDR5-5600 UDIMM delivers the precise 2Rx8 rank, 1.1 V voltage and CL46 timing the motherboard expects. Non-ECC unbuffered design matches the board's 288-pin slots so the system recognises full capacity at rated speed without manual tuning.

Standard JEDEC voltage keeps thermals low

Operating at 1.10 V means the modules run cool and draw minimal power during typical desktop workloads. No heat spreader is fitted, relying on case airflow, and the low voltage helps keep acoustic levels unchanged in a quiet build.

Replaces slower or smaller DDR5 kits

The jump is worthwhile when your current memory runs below 5600 MT/s or totals less than 32 GB and the board's population rules allow this 2Rx8 configuration. Buyers needing ECC, registered DIMMs or higher frequencies should look elsewhere.

Highlights

  • 32 GB capacity doubles memory headroom for demanding workloads
  • DDR5 5600 speed delivers high bandwidth at rated frequency
  • CL46 latency with 1.1 V operation matches controller expectations
  • 2Rx8 288-pin UDIMM form factor fits Supermicro X14SAE-F motherboard
  • Built with major OEM chips for tested stability

Specifications

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 Non-ECC Unbuffered UDIMM Memory
Part NumberMD44800-328K1
Capacity32GB
Type288-Pin DDR5 UDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 Non-ECC Unbuffered UDIMM Motherboard Compatible
Package Content32GB DDR5 5600MHz PC5-44800 2Rx8 1.1V 288-PIN Non-ECC UDIMM KIT

Other versions of this model

5 more in the same range

Same family, different memory, cooler or clock — compare before you commit.

Questions about this item

How do I install this 288-pin DDR5 UDIMM on the Supermicro X14SAE-F, and what step is often missed?

Align the notch on the module with the slot key, press firmly until both retention clips click, then check the motherboard manual for the correct DIMM population order so the 32 GB kit is recognised at 5600 MT/s.

What maintenance or replacement will this 2Rx8 1.10 V module need later?

No routine maintenance is required; the module has no heat spreader and runs at standard JEDEC voltage, so replacement is only necessary if a memory test reports errors or you increase total system capacity beyond the board's supported limit.

What limit appears first under sustained load with this CL46 5600 MT/s kit?

The CAS latency of 46 cycles at 5600 MT/s sets the baseline response time; under continuous heavy workloads the memory controller's thermal throttling or the board's maximum supported rank count will limit performance before the modules themselves do.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.