Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Eight green DDR5 RDIMM sticks in anti-static tray

NEMIX RAM

NEMIX RAM MR51200-9624K8 768GB 8x96GB DDR5 6400 CL52 2Rx4 ECC RDIMM memory upgrade

SKU CH-QF7P-CV9DE

768 GB DDR5-6400 ECC registered RDIMM kit in eight 96 GB modules, CL52 at 1.1 V, validated for the GIGABYTE MS34-CP0 motherboard

  • Capacity768GB (8 x 96GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 6400 (PC5 51200)
  • CAS LatencyCL52
  • Voltage1.10V
  • ECCYes

Size 768GB 8X96GB

Näytä 18 muuta kokoonpanoa
  • 768GB total capacity lets you fully populate eight slots with 96GB modules
  • DDR5 6400 speed with CL52 latency delivers rated throughput at 1.1V
  • Registered ECC architecture offloads the controller and corrects single-bit errors on the fly
  • 288-pin RDIMM form factor matches the GIGABYTE MS34-CP0 motherboard's required slot type
  • 2Rx4 dual-rank organisation enables full-capacity operation across all populated channels

768 GB DDR5 6400 ECC RDIMM kit

This 768 GB kit contains eight 96 GB DDR5 6400 registered ECC RDIMMs built for the GIGABYTE MS34-CP0 motherboard. Each module runs at 1.1 V with CL52 latency and a 2Rx4 organisation. The registered design and ECC protect data integrity in fully populated server configurations.

DDR5 6400 registered ECC limits

DDR5 6400 (PC5-51200) defines the maximum transfer rate and timing the memory controller will negotiate. Registered buffering adds one cycle of address-command delay, and ECC correction works only on single-bit errors per code word. Population rules in the motherboard manual determine whether all eight slots can run at the rated 6400 MT/s.

288-pin RDIMM installation notes

The 288-pin RDIMMs seat in the board's DDR5 DIMM slots following the population order printed in the manual. Misplacing a module or mixing ranks prevents the system from recognising the full 768 GB capacity. Verify the approved slot sequence and firmware version before fitting all eight sticks.

Kohokohdat

  • 768GB total capacity lets you fully populate eight slots with 96GB modules
  • DDR5 6400 speed with CL52 latency delivers rated throughput at 1.1V
  • Registered ECC architecture offloads the controller and corrects single-bit errors on the fly
  • 288-pin RDIMM form factor matches the GIGABYTE MS34-CP0 motherboard's required slot type
  • 2Rx4 dual-rank organisation enables full-capacity operation across all populated channels

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR51200-9624K8
Capacity768GB (8 x 96GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 6400 (PC5 51200)
CAS LatencyCL52
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemGIGABYTE
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content768GB 8X96GB DDR5 6400MHz PC5-51200 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Should I choose the 768GB 8x96GB kit or a smaller capacity for my GIGABYTE MS34-CP0 motherboard?

The 768GB kit uses eight 96GB RDIMMs, filling every slot on boards that support that population. Check your manual for the maximum capacity per slot and the required installation order before deciding.

What does the DDR5 6400 speed rating mean once the modules are installed in a server?

The modules run at 6400 MT/s with CL52 latency at 1.1V, delivering PC5-51200 bandwidth when the memory controller is configured for that speed and the BIOS applies the correct timings.

How does the 288-pin RDIMM interface and registered design affect real-world use?

The 288-pin RDIMM form factor fits only DDR5 RDIMM slots. Registered buffering reduces electrical load on the controller, allowing all eight modules to operate at full 6400 speed while ECC corrects single-bit errors.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.