Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Two green circuit boards with gold contacts and black chips, no heat spreaders

OWC

OWC 16GB (2x8GB) DDR4 2666 CL19 ECC UDIMM Kit PowerEdge R240 T140 T40

SKU CH-6QXM-2P19C

16 GB DDR4 2666 ECC UDIMM kit for PowerEdge R240, T140 and T40 servers

  • Capacity16GB (2 x 8GB)
  • Type288-Pin DDR4 ECC UDIMM
  • SpeedDDR4 2666 (PC4 21300)
  • CAS LatencyCL19
  • Voltage1.2V
  • ECCYes

Capacity 16GB (2 x 8GB)

  • 16 GB kit boosts server capacity with two 8 GB modules
  • DDR4 2666 CL19 delivers responsive multitasking speed
  • ECC protection detects and corrects single-bit data errors
  • JEDEC 1.2 V standard ensures broad platform compatibility
  • Validated for PowerEdge R240 T140 T40 systems

Dell PowerEdge R240 T140 T40 Memory Kit

This 16GB kit contains two 8GB DDR4 ECC unbuffered UDIMMs built for Dell PowerEdge R240 T140 and T40 servers. It targets administrators who need error-correcting memory for stable operation in entry-level rack or tower systems. The modules run at 2666MHz with CL19 latency and 1.2V voltage. Buyers who need registered DIMMs or higher capacities must look elsewhere.

Thermals Noise and Power Draw

Each module operates at the standard DDR4 1.2V without a heat spreader, relying on system airflow for cooling. Unbuffered ECC DIMMs draw minimal power and produce no audible noise themselves. The 2666MHz speed at CL19 follows JEDEC specifications for predictable thermal behaviour in compatible PowerEdge chassis.

Build Fit and Compatibility

The 288-pin UDIMMs install directly into the server memory slots and are validated for PowerEdge R240 T140 and T40 models. Backward compatibility with 2133MHz and 2400MHz systems allows use in older configurations. No extra cables, brackets or software are required for installation.

Kohokohdat

  • 16 GB kit boosts server capacity with two 8 GB modules
  • DDR4 2666 CL19 delivers responsive multitasking speed
  • ECC protection detects and corrects single-bit data errors
  • JEDEC 1.2 V standard ensures broad platform compatibility
  • Validated for PowerEdge R240 T140 T40 systems

Tekniset tiedot

BrandOWC
Part Number2E6D41R8016P
Capacity16GB (2 x 8GB)
Type288-Pin DDR4 ECC UDIMM
SpeedDDR4 2666 (PC4 21300)
CAS LatencyCL19
Voltage1.2V
ECCYes
Buffered/RegisteredUnbuffered
Rank1Rx8
Heat SpreaderNo
Compatible SystemPowerEdge R240
PowerEdge T140
PowerEdge T40

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

How do I install the 288-pin DDR4 ECC UDIMM modules in a PowerEdge R240 and what step is often missed?

Power off the server, open the chassis, align the notch on each 288-pin module with the slot key, press firmly until both retention clips click, then verify in BIOS that all 16GB are recognised at 2666MHz.

What maintenance or replacement will the 1Rx8 ECC unbuffered kit need over its service life?

No routine maintenance is required; the modules have no heat spreader and run at 1.2V, so replacement is only necessary if a DIMM fails or a capacity increase is desired later.

What limit appears first when the CL19 2666MHz kit runs under sustained load in a PowerEdge T140?

The memory controller caps operation at the rated 2666MHz CL19 timing; sustained workloads will not exceed this frequency and the 1.2V supply remains the thermal ceiling.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.