OWC 8GB DDR4 2133 CL15 1.2V UDIMM memory upgrade for HP Envy Phoenix 860
- 8GB
- 288-Pin DDR4 Non-EC…
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
OWC
8GB DDR4 2133 CL15 SODIMM module built for NCR RealPOS XR7 Plus POS (7703) systems
This 8 GB DDR4 SODIMM is built for the NCR RealPOS XR7 Plus POS (7703). It delivers a single-module capacity increase for point-of-sale terminals that require 260-pin PC4-17000 memory. The unbuffered non-ECC design matches the original system specification exactly. Buyers needing ECC protection or registered modules cannot use this part.
Operating at 1.2 V, the module draws minimal power and generates little heat during continuous retail operation. No heat spreader is fitted, relying on the chassis airflow of the POS unit. The CL15 latency at 2133 MHz keeps timing tight without raising voltage. Systems with restricted ventilation or high ambient temperatures should verify thermal headroom before installation.
JEDEC and RoHS compliance ensure the upgrade is warranty-safe for the host terminal. OWC provides a limited lifetime warranty with free technical support and an advanced replacement programme. A basic installation video is available to guide the DIY process. No additional software, drivers or accessories are bundled with the module.
| Brand | OWC |
|---|---|
| Part Number | 2S1D42R808GB |
| Capacity | 8GB |
| Type | 260-Pin DDR4 Non-ECC SODIMM |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.2V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | NCR POS RealPOS XR7 Plus POS (7703) |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
Power off the terminal and unplug it, then open the memory access panel. Align the notch on the 260-pin module with the slot key and press firmly until both side clips click. The step often missed is verifying the clips have fully locked on both sides.
No scheduled maintenance is required for the module itself. Keep the system vents clear of dust so the 1.2V SODIMM stays within its thermal limits. Replacement is only needed if a memory test reports errors or the terminal's workload outgrows the 8GB capacity.
The 8GB capacity ceiling is reached before the DDR4 2133 bandwidth or CL15 latency become bottlenecks. Once the terminal commits more than 8GB, the OS swaps to storage and responsiveness drops sharply.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?