Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Two black 240-pin DDR3 desktop DIMMs without heat spreaders

OWC

OWC 8GB (2x4GB) DDR3 1600 CL11 1.5V Desktop RAM

SKU CH-A99V-MGSXG

An 8 GB dual-channel DDR3 kit running at 1600 MHz with CL11 latency and 1.5 V operation for desktop upgrades

  • Capacity8GB (2 x 4GB)
  • SpeedDDR3 1600 (PC3 12800)
  • CAS LatencyCL11
  • Voltage1.5V
  • ECCNo
  • Buffered/RegisteredUnbuffered

Capacity 8GB (2 x 4GB)

  • Dual-channel kit doubles bandwidth with two matched 4GB modules
  • JEDEC-standard DDR3 1600 CL11 runs at stock voltage for broad compatibility
  • 5 V operation keeps power draw low on older desktop platforms
  • Unbuffered non-ECC design installs in standard 240-pin DIMM slots without configuration
  • 8 GB total capacity lets you open more apps and larger files simultaneously

OWC DDR3 1600 dual-channel kit

This kit provides eight gigabytes of DDR3 memory split across two four-gigabyte modules running at 1600 MT/s with CL11 latency at 1.5 volts. It is built for desktop and workstation boards that accept 240-pin unbuffered non-ECC DIMMs.

Sustained-load behaviour

JEDEC-standard timings and voltage keep the modules stable during long rendering, compilation or virtual-machine sessions without throttling. The dual-channel layout doubles peak bandwidth over a single stick, so throughput stays consistent when all slots are populated.

Installation notes

Align the notch on each 240-pin DIMM with the motherboard key and press firmly until the retention clips click; no heat spreader means low-profile coolers clear the modules easily. The most common issue is mixing these sticks with faster or lower-latency kits, which forces the board to run at the slowest common settings.

Kohokohdat

  • Dual-channel kit doubles bandwidth with two matched 4GB modules
  • JEDEC-standard DDR3 1600 CL11 runs at stock voltage for broad compatibility
  • 5 V operation keeps power draw low on older desktop platforms
  • Unbuffered non-ECC design installs in standard 240-pin DIMM slots without configuration
  • 8 GB total capacity lets you open more apps and larger files simultaneously

Tekniset tiedot

BrandOWC
Part Number1U6D32R8008P
Capacity8GB (2 x 4GB)
SpeedDDR3 1600 (PC3 12800)
CAS LatencyCL11
Voltage1.5V
ECCNo
Buffered/RegisteredUnbuffered
Multi-channel KitDual Channel Kit
ColorBlack
Heat SpreaderNo
Recommend UseDesktops
LED ColorNone

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Will this kit work in a desktop that takes 240-pin DDR3 DIMMs?

Yes, the kit uses standard 240-pin unbuffered DDR3 DIMMs rated at 1600 MHz CL11 and 1.5 V, matching the JEDEC PC3-12800 specification for desktop and workstation boards.

Is the memory compatible with a system that only supports non-ECC modules?

The modules are non-ECC, so they will work in any desktop or workstation that requires standard unbuffered DDR3 without error correction.

Can I install these two 4 GB sticks alongside existing DDR3 memory?

You can add the pair to empty slots, but for best stability all installed DIMMs should share the same speed, voltage and timing; mixing different CL values or voltages may force the system to run at the lowest common settings.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.