SanDisk
SanDisk Cruzer Blade 8 GB USB 2.0 USB flash drive Black SDCZ50-008G-B35
391.99 $
0.00502294BTC
במלאי
Computer Memory Solutions
Computer Memory Solutions 16GB (2x8GB) DDR4 2666 CL19 DIMM for OptiPlex 7060/XE3
A 16 GB DDR4 kit of two 8 GB unbuffered DIMMs at 2666 MHz CL19 for Dell OptiPlex 7060 and XE3 systems
- Capacity16GB (2 x 8GB)
- Type288-Pin DDR4 SDRAM
- SpeedDDR4 2666 (PC4 21300)
- CAS LatencyCL19
- Timing19-19-19
- Voltage1.20V
- 16 GB dual-channel kit boosts multitasking headroom
- 2666 MHz DDR4 speed matches OptiPlex 7060 spec
- CL19 latency keeps response tight at 1.2 V
- Guaranteed fit for OptiPlex 7060 SFF, Tower and XE3 Tower
- Two 8 GB unbuffered DIMMs install in seconds
16 GB DDR4 kit for OptiPlex 7060 and XE3
This 16 GB kit uses two 8 GB DDR4 DIMMs rated at 2666 MHz with CL19 timing. It targets owners of Dell OptiPlex 7060 SFF, OptiPlex 7060 Tower or OptiPlex XE3 Tower systems who need more memory for everyday workloads. The modules are unbuffered, non-ECC and run at 1.2 V.
No heat spreaders and major-brand chips
The sticks ship without heat spreaders, keeping the profile low for small-form-factor chassis. Major-brand chipsets are used to reduce compatibility issues. All installed memory will operate at the speed of the slowest module or the processor limit, so mixing with slower RAM reduces overall throughput.
Simple 288-pin DIMM installation
Installation follows the standard 288-pin DDR4 DIMM procedure for the four available slots. Buyers who need more than 64 GB total capacity or who require ECC or registered memory cannot use this kit. Ensure the system firmware is current to avoid recognition problems with 2Rx8 rank modules.
נקודות עיקריות
- 16 GB dual-channel kit boosts multitasking headroom
- 2666 MHz DDR4 speed matches OptiPlex 7060 spec
- CL19 latency keeps response tight at 1.2 V
- Guaranteed fit for OptiPlex 7060 SFF, Tower and XE3 Tower
- Two 8 GB unbuffered DIMMs install in seconds
מפרט טכני
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM1024642666DIMM |
| Capacity | 16GB (2 x 8GB) |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2666 (PC4 21300) |
| CAS Latency | CL19 |
| Timing | 19-19-19 |
| Voltage | 1.20V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Dell OptiPlex 7060 Small Form Factor (SFF), OptiPlex 7060Tower, OptiPlex XE3 Tower |
| Package Content | 2 Memory RAM Sticks |
שאלות על הפריט הזה
Will the 288-pin DDR4 modules need replacement if I later expand to the 64 GB maximum?
The kit occupies two of the four slots with 8 GB sticks, so you can add two more modules later without removing these.
What speed ceiling will the memory hit first during long workloads?
All installed modules run at the slowest speed present, so the 2666 MHz CL19 rating sets the limit for the whole system.
How much heat and power will the 1.2 V unbuffered DIMMs produce running all day?
At 1.2 V with no heat spreader, each 8 GB stick draws minimal power and stays cool under continuous load.
גם במדף הזה
לקוחות השוו בין אלה
אותו מדף, אותה קופה — שמונה מטבעות קריפטו ונעילת שער ל-30 דקות.
