NEMIX RAM 96GB DDR5 5600 CL46 2Rx4 ECC RDIMM for GIGABYTE MZ73-LM0 memory upgrade

Exact-match DDR5-5600 upgrade for GIGABYTE MZ73-LM0

This 96GB DDR5 5600 CL46 2Rx4 ECC RDIMM kit is built as a drop-in upgrade for the GIGABYTE MZ73-LM0 motherboard. It matches the board's required 288-pin registered form factor, voltage and timing so the memory controller recognises the full capacity at rated speed. Server administrators and IT teams deploying this platform can install it without manual tuning.

Registered ECC build with 288-pin RDIMM connector

The modules use a registered architecture that buffers address and command signals, allowing every slot to run fully populated at 96GB per module. ECC circuitry catches and corrects single-bit errors on the fly, preventing silent data corruption and unplanned reboots. The 288-pin RDIMM edge connector fits only motherboards wired for registered DDR5; it will not seat in UDIMM or SODIMM slots.

1.1V operation keeps thermals and power low

Running at 1.10V, the kit draws minimal power for its density, reducing heat output inside dense server chassis. No heat spreader is fitted, so airflow across the bare PCB is the primary cooling path; standard server fan walls handle this without extra noise. The low voltage also eases load on the motherboard's VRM phases during sustained workloads.