NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
Kingston Technology Corp.
1 GB DDR2 667 registered ECC server memory with CL5 latency and 1.80 V operation
This 1 GB DDR2 667 (PC2 5300) module is built for servers and workstations that require registered ECC memory. It fits 240-pin DIMM slots and operates at a standard 1.80 V with CL5 latency. The registered buffer helps maintain signal integrity on heavily populated motherboards. It is not suited for consumer desktops or laptops that use unbuffered non-ECC memory.
Without a heat spreader the module relies on case airflow for cooling, which is typical for registered DDR2 server DIMMs. Power draw stays low at the standard 1.80 V, so additional cooling is rarely needed in a properly ventilated chassis. Acoustic impact is negligible because the component has no moving parts. Servers with restricted airflow should still verify adequate circulation around the memory slots.
The 240-pin form factor requires a motherboard with DDR2 registered DIMM slots and chipset support for ECC. Each stick adds 1 GB of capacity, so larger memory configurations need multiple free slots. The registered design limits compatibility to platforms that explicitly support buffered memory. Builders needing higher densities or faster speeds must select different modules.
| Brand | Kingston |
|---|---|
| Model | KVR667D2D8P5/1G |
| Capacity | 1GB |
| Type | 240-Pin DDR2 SDRAM |
| Speed | DDR2 667 (PC2 5300) |
| CAS Latency | CL5 |
| Voltage | 1.80V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Heat Spreader | No |
| Težina pošiljke | 0.09 kg |
| Dimenzije pakiranja | 170 × 56 × 15 mm |
Align the notch with the slot key, press firmly until both retention clips click, then verify the server BIOS recognises the registered buffer at POST.
No routine maintenance is required; replace only if memory diagnostics report uncorrectable ECC errors or the server fails to boot.
The DDR2 667 bandwidth ceiling is reached before thermal limits, since the module has no heat spreader and operates at standard voltage.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?