NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Vi tar emot kryptovaluta — så att kryptot du äger kan köpa riktig hårdvara.Betala med krypto, använd det till riktig hårdvara. Fri, försäkrad frakt över hela världen vid köp över 399 $. Neutrala, omärkta ytterkartonger, skickade från Tyskland.Fri, försäkrad frakt över 399 $. Din kurs låses i 30 minuter så snart kassan öppnas.Kursen låst i 30 minuter. Varje artikel är förseglad, har kontrollerat serienummer och täcks av 24 månaders garanti.Förseglad, 24 månaders garanti.
Kingston Technology Corp.
1 GB DDR2 667 registered ECC server memory with CL5 latency and 1.80 V operation
This 1 GB DDR2 667 (PC2 5300) module is built for servers and workstations that require registered ECC memory. It fits 240-pin DIMM slots and operates at a standard 1.80 V with CL5 latency. The registered buffer helps maintain signal integrity on heavily populated motherboards. It is not suited for consumer desktops or laptops that use unbuffered non-ECC memory.
Without a heat spreader the module relies on case airflow for cooling, which is typical for registered DDR2 server DIMMs. Power draw stays low at the standard 1.80 V, so additional cooling is rarely needed in a properly ventilated chassis. Acoustic impact is negligible because the component has no moving parts. Servers with restricted airflow should still verify adequate circulation around the memory slots.
The 240-pin form factor requires a motherboard with DDR2 registered DIMM slots and chipset support for ECC. Each stick adds 1 GB of capacity, so larger memory configurations need multiple free slots. The registered design limits compatibility to platforms that explicitly support buffered memory. Builders needing higher densities or faster speeds must select different modules.
| Brand | Kingston |
|---|---|
| Model | KVR667D2D8P5/1G |
| Capacity | 1GB |
| Type | 240-Pin DDR2 SDRAM |
| Speed | DDR2 667 (PC2 5300) |
| CAS Latency | CL5 |
| Voltage | 1.80V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Heat Spreader | No |
| Fraktvikt | 0.09 kg |
| Paketstorlek | 170 × 56 × 15 mm |
Align the notch with the slot key, press firmly until both retention clips click, then verify the server BIOS recognises the registered buffer at POST.
No routine maintenance is required; replace only if memory diagnostics report uncorrectable ECC errors or the server fails to boot.
The DDR2 667 bandwidth ceiling is reached before thermal limits, since the module has no heat spreader and operates at standard voltage.
Även i den här avdelningen
Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.
Det du betalar med, och det du ser priserna i.
Skickas från din plånbok i kassan
Endast visning — katalogen är prissatt i US-dollar
Ingen valuta matchar.
Välj det språk du vill att webbplatsen ska visas på.
Ny här?
Har du redan ett konto?
Det finns ingen automatisk återställning: den här butiken skickar inga e-postmeddelanden, så det finns ingen engångslänk att begära. Lämna adressen kopplad till kontot, så hanteras den för hand.
Förfrågan noterad
Inget är på väg till din inkorg — den här butiken skickar aldrig e-post. Någon tar hand om detta manuellt.
Kom du på det?