EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
Приемаме криптовалута — така монетите, които притежавате, могат да купят истински хардуер.Платете с крипто, похарчете го за истински хардуер. Безплатна застрахована доставка по целия свят над 399 $. Неутрални кашони без марка, изпратени от Германия.Безплатна застрахована доставка над 399 $. Курсът Ви е заключен за 30 минути веднага след отварянето на касата.Курс, заключен за 30 минути. Всеки артикул е запечатан, серийният му номер е проверен, и е покрит с 24-месечна гаранция.Запечатан, 24-месечна гаранция.
Kingston Technology Corp.
1 GB DDR2 667 registered ECC server memory with CL5 latency and 1.80 V operation
This 1 GB DDR2 667 (PC2 5300) module is built for servers and workstations that require registered ECC memory. It fits 240-pin DIMM slots and operates at a standard 1.80 V with CL5 latency. The registered buffer helps maintain signal integrity on heavily populated motherboards. It is not suited for consumer desktops or laptops that use unbuffered non-ECC memory.
Without a heat spreader the module relies on case airflow for cooling, which is typical for registered DDR2 server DIMMs. Power draw stays low at the standard 1.80 V, so additional cooling is rarely needed in a properly ventilated chassis. Acoustic impact is negligible because the component has no moving parts. Servers with restricted airflow should still verify adequate circulation around the memory slots.
The 240-pin form factor requires a motherboard with DDR2 registered DIMM slots and chipset support for ECC. Each stick adds 1 GB of capacity, so larger memory configurations need multiple free slots. The registered design limits compatibility to platforms that explicitly support buffered memory. Builders needing higher densities or faster speeds must select different modules.
| Brand | Kingston |
|---|---|
| Model | KVR667D2D8P5/1G |
| Capacity | 1GB |
| Type | 240-Pin DDR2 SDRAM |
| Speed | DDR2 667 (PC2 5300) |
| CAS Latency | CL5 |
| Voltage | 1.80V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Heat Spreader | No |
| Тегло на пратката | 0.09 kg |
| Размери на опаковката | 170 × 56 × 15 mm |
Align the notch with the slot key, press firmly until both retention clips click, then verify the server BIOS recognises the registered buffer at POST.
No routine maintenance is required; replace only if memory diagnostics report uncorrectable ECC errors or the server fails to boot.
The DDR2 667 bandwidth ceiling is reached before thermal limits, since the module has no heat spreader and operates at standard voltage.
Още от този рафт
Същият рафт, същата каса — осем монети и заключване на курса за 30 минути.
Това, което изпращате, и това, в което четете цените.
Изпратено от Вашия портфейл при поръчката
Само за визуализация — каталогът е в долари
Никоя валута не съответства.
Изберете езика, на който сайтът да Ви говори.
Няма съвпадащ език.
Нови сте тук?
Вече имате профил?
Няма автоматично нулиране: този магазин не изпраща имейли, така че няма еднократна връзка, която да поискате. Оставете адреса в профила си и той ще бъде обработен ръчно.
Заявката е приета
Нищо няма да пристигне във Вашата пощенска кутия — този магазин изобщо не изпраща имейли. Заявките се обработват ръчно.
Спомнихте си я?