Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Green 240-pin DDR2 server memory module with black chips, no heat spreader

Kingston Technology Corp.

Kingston Technology Corp. KVR667D2D8P5/1G 1GB DDR2 667 ECC Registered server RAM

SKU CH-7YZJ-ZTCNC MPN KVR667D2D8P5/1G

1 GB DDR2 667 registered ECC server memory with CL5 latency and 1.80 V operation

  • Capacity1GB
  • Type240-Pin DDR2 SDRAM
  • SpeedDDR2 667 (PC2 5300)
  • CAS LatencyCL5
  • Voltage1.80V
  • ECCYes
  • ECC protection detects and corrects single-bit memory errors
  • Registered buffering reduces electrical load on the server memory controller
  • DDR2 667 speed delivers 5300 MB/s bandwidth for compatible platforms
  • CL5 latency timing supports stable operation at rated frequency
  • 80 V operating voltage matches standard DDR2 server specifications

1 GB DDR2 667 ECC Registered module

This 1 GB DDR2 667 (PC2 5300) module is built for servers and workstations that require registered ECC memory. It fits 240-pin DIMM slots and operates at a standard 1.80 V with CL5 latency. The registered buffer helps maintain signal integrity on heavily populated motherboards. It is not suited for consumer desktops or laptops that use unbuffered non-ECC memory.

Thermals and power in normal use

Without a heat spreader the module relies on case airflow for cooling, which is typical for registered DDR2 server DIMMs. Power draw stays low at the standard 1.80 V, so additional cooling is rarely needed in a properly ventilated chassis. Acoustic impact is negligible because the component has no moving parts. Servers with restricted airflow should still verify adequate circulation around the memory slots.

Build integration and trade-offs

The 240-pin form factor requires a motherboard with DDR2 registered DIMM slots and chipset support for ECC. Each stick adds 1 GB of capacity, so larger memory configurations need multiple free slots. The registered design limits compatibility to platforms that explicitly support buffered memory. Builders needing higher densities or faster speeds must select different modules.

Helstu kostir

  • ECC protection detects and corrects single-bit memory errors
  • Registered buffering reduces electrical load on the server memory controller
  • DDR2 667 speed delivers 5300 MB/s bandwidth for compatible platforms
  • CL5 latency timing supports stable operation at rated frequency
  • 80 V operating voltage matches standard DDR2 server specifications

Tæknilýsing

BrandKingston
ModelKVR667D2D8P5/1G
Capacity1GB
Type240-Pin DDR2 SDRAM
SpeedDDR2 667 (PC2 5300)
CAS LatencyCL5
Voltage1.80V
ECCYes
Buffered/RegisteredRegistered
Heat SpreaderNo
Sendingarþyngd0.09 kg
Stærð sendingar170 × 56 × 15 mm

Spurningar um þessa vöru

How do I install this 240-Pin DDR2 ECC Registered module, and what step is often missed?

Align the notch with the slot key, press firmly until both retention clips click, then verify the server BIOS recognises the registered buffer at POST.

What maintenance or replacement will this 1GB DDR2 667 module need over time?

No routine maintenance is required; replace only if memory diagnostics report uncorrectable ECC errors or the server fails to boot.

What limit appears first when this CL5 1.80V registered DIMM runs under sustained load?

The DDR2 667 bandwidth ceiling is reached before thermal limits, since the module has no heat spreader and operates at standard voltage.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.