OWC 4GB DDR3 1333 CL9 2Rx8 204-pin 1.5V SODIMM memory upgrade
- 4GB
- 204-Pin DDR3 Non-EC…
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
OWC
Adds 4 GB of DDR3 1066 CL7 memory to Lenovo ThinkCentre M58p SFF or Tower systems
This 4GB DDR3 module is built for Lenovo ThinkCentre M58p SFF and M58p Tower systems. It delivers a straightforward capacity increase for older workstations that still use DDR3 memory. The single DIMM fits directly into an available 240-pin slot without configuration changes.
The module runs at the standard 1.5V DDR3 voltage with CL7 latency at 1066 MHz. As an unbuffered non-ECC DIMM without a heat spreader, it operates within normal desktop thermal limits and adds minimal power draw to the system. No active cooling or special airflow is required beyond the case fans already present.
The 240-pin UDIMM installs in either the small-form-factor or tower chassis of the supported ThinkCentre models. It leaves remaining slots free for additional matched modules if the board allows. Builders needing ECC, registered memory or speeds beyond DDR3 1066 should look elsewhere.
| Brand | OWC |
|---|---|
| Part Number | 8U5D32R804GB |
| Capacity | 4GB |
| Type | 240-Pin DDR3 Non-ECC UDIMM |
| Speed | DDR3 1066 (PC3 8500) |
| CAS Latency | CL7 |
| Voltage | 1.5V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | Lenovo ThinkCentre M58p SFF Lenovo ThinkCentre M58p Tower |
Druge verzije ovog modela
Ista obitelj, različita memorija, hladnjak ili frekvencija — usporedite prije kupnje.
Power off and unplug the system, open the case, align the notch on the 240-pin DDR3 module with the slot key, press firmly until both retention clips click, then verify in BIOS that the 4GB 1066 CL7 module is detected at 1.5V.
No scheduled maintenance is required; keep interior dust-free for airflow. Replace only if memory diagnostics report errors or if you upgrade capacity beyond the single 4GB 2Rx8 UDIMM.
The 1066 MT/s data rate and CL7 latency set the throughput ceiling; sustained loads will hit that bandwidth limit before the 1.5V thermal envelope becomes a concern.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Nema odgovarajućeg jezika.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?