OWC 4GB DDR3 1333 CL9 2Rx8 204-pin 1.5V SODIMM memory upgrade
- 4GB
- 204-Pin DDR3 Non-EC…
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
OWC
Adds 4 GB of DDR3 1066 CL7 memory to Lenovo ThinkCentre M58p SFF or Tower systems
This 4GB DDR3 module is built for Lenovo ThinkCentre M58p SFF and M58p Tower systems. It delivers a straightforward capacity increase for older workstations that still use DDR3 memory. The single DIMM fits directly into an available 240-pin slot without configuration changes.
The module runs at the standard 1.5V DDR3 voltage with CL7 latency at 1066 MHz. As an unbuffered non-ECC DIMM without a heat spreader, it operates within normal desktop thermal limits and adds minimal power draw to the system. No active cooling or special airflow is required beyond the case fans already present.
The 240-pin UDIMM installs in either the small-form-factor or tower chassis of the supported ThinkCentre models. It leaves remaining slots free for additional matched modules if the board allows. Builders needing ECC, registered memory or speeds beyond DDR3 1066 should look elsewhere.
| Brand | OWC |
|---|---|
| Part Number | 8U5D32R804GB |
| Capacity | 4GB |
| Type | 240-Pin DDR3 Non-ECC UDIMM |
| Speed | DDR3 1066 (PC3 8500) |
| CAS Latency | CL7 |
| Voltage | 1.5V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | Lenovo ThinkCentre M58p SFF Lenovo ThinkCentre M58p Tower |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
Power off and unplug the system, open the case, align the notch on the 240-pin DDR3 module with the slot key, press firmly until both retention clips click, then verify in BIOS that the 4GB 1066 CL7 module is detected at 1.5V.
No scheduled maintenance is required; keep interior dust-free for airflow. Replace only if memory diagnostics report errors or if you upgrade capacity beyond the single 4GB 2Rx8 UDIMM.
The 1066 MT/s data rate and CL7 latency set the throughput ceiling; sustained loads will hit that bandwidth limit before the 1.5V thermal envelope becomes a concern.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?