OWC 4GB DDR3 1333 CL9 2Rx8 204-pin 1.5V SODIMM memory upgrade
- 4GB
- 204-Pin DDR3 Non-EC…
Vi tar emot kryptovaluta — så att kryptot du äger kan köpa riktig hårdvara.Betala med krypto, använd det till riktig hårdvara. Fri, försäkrad frakt över hela världen vid köp över 399 $. Neutrala, omärkta ytterkartonger, skickade från Tyskland.Fri, försäkrad frakt över 399 $. Din kurs låses i 30 minuter så snart kassan öppnas.Kursen låst i 30 minuter. Varje artikel är förseglad, har kontrollerat serienummer och täcks av 24 månaders garanti.Förseglad, 24 månaders garanti.
OWC
Adds 4 GB of DDR3 1066 CL7 memory to Lenovo ThinkCentre M58p SFF or Tower systems
This 4GB DDR3 module is built for Lenovo ThinkCentre M58p SFF and M58p Tower systems. It delivers a straightforward capacity increase for older workstations that still use DDR3 memory. The single DIMM fits directly into an available 240-pin slot without configuration changes.
The module runs at the standard 1.5V DDR3 voltage with CL7 latency at 1066 MHz. As an unbuffered non-ECC DIMM without a heat spreader, it operates within normal desktop thermal limits and adds minimal power draw to the system. No active cooling or special airflow is required beyond the case fans already present.
The 240-pin UDIMM installs in either the small-form-factor or tower chassis of the supported ThinkCentre models. It leaves remaining slots free for additional matched modules if the board allows. Builders needing ECC, registered memory or speeds beyond DDR3 1066 should look elsewhere.
| Brand | OWC |
|---|---|
| Part Number | 8U5D32R804GB |
| Capacity | 4GB |
| Type | 240-Pin DDR3 Non-ECC UDIMM |
| Speed | DDR3 1066 (PC3 8500) |
| CAS Latency | CL7 |
| Voltage | 1.5V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | Lenovo ThinkCentre M58p SFF Lenovo ThinkCentre M58p Tower |
Andra versioner av den här modellen
Samma familj, men olika minne, kylning eller klockfrekvens — jämför innan du bestämmer dig.
Power off and unplug the system, open the case, align the notch on the 240-pin DDR3 module with the slot key, press firmly until both retention clips click, then verify in BIOS that the 4GB 1066 CL7 module is detected at 1.5V.
No scheduled maintenance is required; keep interior dust-free for airflow. Replace only if memory diagnostics report errors or if you upgrade capacity beyond the single 4GB 2Rx8 UDIMM.
The 1066 MT/s data rate and CL7 latency set the throughput ceiling; sustained loads will hit that bandwidth limit before the 1.5V thermal envelope becomes a concern.
Även i den här avdelningen
Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.
Det du betalar med, och det du ser priserna i.
Skickas från din plånbok i kassan
Endast visning — katalogen är prissatt i US-dollar
Ingen valuta matchar.
Välj det språk du vill att webbplatsen ska visas på.
Inga språk matchar.
Ny här?
Har du redan ett konto?
Det finns ingen automatisk återställning: den här butiken skickar inga e-postmeddelanden, så det finns ingen engångslänk att begära. Lämna adressen kopplad till kontot, så hanteras den för hand.
Förfrågan noterad
Inget är på väg till din inkorg — den här butiken skickar aldrig e-post. Någon tar hand om detta manuellt.
Kom du på det?