OWC 4GB DDR3 1333 CL9 2Rx8 204-pin 1.5V SODIMM memory upgrade
- 4GB
- 204-Pin DDR3 Non-EC…
Приемаме криптовалута — така монетите, които притежавате, могат да купят истински хардуер.Платете с крипто, похарчете го за истински хардуер. Безплатна застрахована доставка по целия свят над 399 $. Неутрални кашони без марка, изпратени от Германия.Безплатна застрахована доставка над 399 $. Курсът Ви е заключен за 30 минути веднага след отварянето на касата.Курс, заключен за 30 минути. Всеки артикул е запечатан, серийният му номер е проверен, и е покрит с 24-месечна гаранция.Запечатан, 24-месечна гаранция.
OWC
Adds 4 GB of DDR3 1066 CL7 memory to Lenovo ThinkCentre M58p SFF or Tower systems
This 4GB DDR3 module is built for Lenovo ThinkCentre M58p SFF and M58p Tower systems. It delivers a straightforward capacity increase for older workstations that still use DDR3 memory. The single DIMM fits directly into an available 240-pin slot without configuration changes.
The module runs at the standard 1.5V DDR3 voltage with CL7 latency at 1066 MHz. As an unbuffered non-ECC DIMM without a heat spreader, it operates within normal desktop thermal limits and adds minimal power draw to the system. No active cooling or special airflow is required beyond the case fans already present.
The 240-pin UDIMM installs in either the small-form-factor or tower chassis of the supported ThinkCentre models. It leaves remaining slots free for additional matched modules if the board allows. Builders needing ECC, registered memory or speeds beyond DDR3 1066 should look elsewhere.
| Brand | OWC |
|---|---|
| Part Number | 8U5D32R804GB |
| Capacity | 4GB |
| Type | 240-Pin DDR3 Non-ECC UDIMM |
| Speed | DDR3 1066 (PC3 8500) |
| CAS Latency | CL7 |
| Voltage | 1.5V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | Lenovo ThinkCentre M58p SFF Lenovo ThinkCentre M58p Tower |
Други версии на този модел
Същото семейство, различна памет, охладител или честота — сравнете, преди да решите.
Power off and unplug the system, open the case, align the notch on the 240-pin DDR3 module with the slot key, press firmly until both retention clips click, then verify in BIOS that the 4GB 1066 CL7 module is detected at 1.5V.
No scheduled maintenance is required; keep interior dust-free for airflow. Replace only if memory diagnostics report errors or if you upgrade capacity beyond the single 4GB 2Rx8 UDIMM.
The 1066 MT/s data rate and CL7 latency set the throughput ceiling; sustained loads will hit that bandwidth limit before the 1.5V thermal envelope becomes a concern.
Още от този рафт
Същият рафт, същата каса — осем монети и заключване на курса за 30 минути.
Това, което изпращате, и това, в което четете цените.
Изпратено от Вашия портфейл при поръчката
Само за визуализация — каталогът е в долари
Никоя валута не съответства.
Изберете езика, на който сайтът да Ви говори.
Няма съвпадащ език.
Нови сте тук?
Вече имате профил?
Няма автоматично нулиране: този магазин не изпраща имейли, така че няма еднократна връзка, която да поискате. Оставете адреса в профила си и той ще бъде обработен ръчно.
Заявката е приета
Нищо няма да пристигне във Вашата пощенска кутия — този магазин изобщо не изпраща имейли. Заявките се обработват ръчно.
Спомнихте си я?