OWC 4GB DDR3 1333 CL9 2Rx8 204-pin 1.5V SODIMM memory upgrade
- 4GB
- 204-Pin DDR3 Non-EC…
Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.
OWC
Adds 4 GB of DDR3 1066 CL7 memory to Lenovo ThinkCentre M58p SFF or Tower systems
This 4GB DDR3 module is built for Lenovo ThinkCentre M58p SFF and M58p Tower systems. It delivers a straightforward capacity increase for older workstations that still use DDR3 memory. The single DIMM fits directly into an available 240-pin slot without configuration changes.
The module runs at the standard 1.5V DDR3 voltage with CL7 latency at 1066 MHz. As an unbuffered non-ECC DIMM without a heat spreader, it operates within normal desktop thermal limits and adds minimal power draw to the system. No active cooling or special airflow is required beyond the case fans already present.
The 240-pin UDIMM installs in either the small-form-factor or tower chassis of the supported ThinkCentre models. It leaves remaining slots free for additional matched modules if the board allows. Builders needing ECC, registered memory or speeds beyond DDR3 1066 should look elsewhere.
| Brand | OWC |
|---|---|
| Part Number | 8U5D32R804GB |
| Capacity | 4GB |
| Type | 240-Pin DDR3 Non-ECC UDIMM |
| Speed | DDR3 1066 (PC3 8500) |
| CAS Latency | CL7 |
| Voltage | 1.5V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | Lenovo ThinkCentre M58p SFF Lenovo ThinkCentre M58p Tower |
Aðrar útgáfur af þessari vöru
Sama fjölskylda, mismunandi minni, kælingu eða klukkuhraða — berðu saman áður en þú ákveður þig.
Power off and unplug the system, open the case, align the notch on the 240-pin DDR3 module with the slot key, press firmly until both retention clips click, then verify in BIOS that the 4GB 1066 CL7 module is detected at 1.5V.
No scheduled maintenance is required; keep interior dust-free for airflow. Replace only if memory diagnostics report errors or if you upgrade capacity beyond the single 4GB 2Rx8 UDIMM.
The 1066 MT/s data rate and CL7 latency set the throughput ceiling; sustained loads will hit that bandwidth limit before the 1.5V thermal envelope becomes a concern.
Einnig í þessum vöruflokki
Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.
Það sem þú greiðir í, og það sem þú sérð verð í.
Sent úr veskinu þínu í greiðsluferlinu
Aðeins til skýringar — verð í vörulistanum eru í Bandaríkjadölum
Enginn gjaldmiðill passar við það.
Veldu tungumálið sem síðan talar við þig á.
Ekkert tungumál fannst.
Fyrsta heimsókn?
Áttu þegar aðgang?
Það er engin sjálfvirk endurstilling: þessi verslun sendir engan tölvupóst, svo það er enginn einnota tengill til að biðja um. Skildu netfangið eftir á aðganginum og einhver sinnir því handvirkt.
Beiðni skráð
Ekkert er á leiðinni í pósthólfið þitt — þessi verslun sendir engan tölvupóst. Einhver sinnir þessu handvirkt.
Mundir þú það?