NEMIX RAM 4GB (2x2GB) DDR2 667 desktop RAM
- 4GB (2 x 2GB)
- 240-Pin DDR2 UDIMM
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
NEMIX RAM
A four-module kit provides 8 GB of DDR2 800 desktop memory at CL6 latency and 1.8 V
Capacity 8GB (4 x 2GB)
This NEMIX RAM kit provides 8 GB of desktop memory across four 2 GB modules. It uses the DDR2 800 standard, also labelled PC2-6400, with a CAS latency of CL6 and a default voltage of 1.8 V. The sticks are 240-pin unbuffered UDIMMs without ECC or heat spreaders.
The kit suits older desktop motherboards that accept DDR2 UDIMMs and can run at 800 MHz with 1.8 V operation. Builders repairing or upgrading legacy workstations or basic office PCs will find it a direct match. Systems that require registered or ECC memory, or boards limited to slower DDR2 speeds, should look elsewhere.
The decisive figure is the DDR2 800 (PC2-6400) speed rating combined with CL6 timing at 1.8 V. If the motherboard specifies this exact speed and voltage the kit will slot in and run at its rated settings without further adjustment.
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM DDR2 Orignial Desktop PC 240-Pin Non-ECC Unbuffered UDIMM Memory |
| Model | Original Series DDR2 Desktop PC Memory Solutions |
| Part Number | MD6400-228K4 |
| Capacity | 8GB (4 x 2GB) |
| Type | 240-Pin DDR2 UDIMM |
| Speed | DDR2 800 (PC2 6400) |
| CAS Latency | CL6 |
| Voltage | 1.80V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Heat Spreader | No |
| Features | DDR2 Non-ECC Unbuffered UDIMM Motherboard Compatible |
| LED Color | None |
A modell további verziói
Ugyanaz a termékcsalád, eltérő memória, hűtés vagy órajel — hasonlítsa össze, mielőtt dönt.
The kit uses the standard 240-pin DDR2 UDIMM form factor, so it fits any desktop board with DDR2 DIMM slots.
Open the retention clips, align the notch on each module with the slot key, press down firmly until both clips snap shut, then verify all four are fully latched.
DDR2 memory has no moving parts and no wear cycle; it typically runs for the life of the system unless physically damaged or a voltage fault occurs.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Nincs egyező nyelv.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?