NEMIX RAM 4GB (2x2GB) DDR2 667 desktop RAM
- 4GB (2 x 2GB)
- 240-Pin DDR2 UDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
NEMIX RAM
A four-module kit provides 8 GB of DDR2 800 desktop memory at CL6 latency and 1.8 V
Capacity 8GB (4 x 2GB)
This NEMIX RAM kit provides 8 GB of desktop memory across four 2 GB modules. It uses the DDR2 800 standard, also labelled PC2-6400, with a CAS latency of CL6 and a default voltage of 1.8 V. The sticks are 240-pin unbuffered UDIMMs without ECC or heat spreaders.
The kit suits older desktop motherboards that accept DDR2 UDIMMs and can run at 800 MHz with 1.8 V operation. Builders repairing or upgrading legacy workstations or basic office PCs will find it a direct match. Systems that require registered or ECC memory, or boards limited to slower DDR2 speeds, should look elsewhere.
The decisive figure is the DDR2 800 (PC2-6400) speed rating combined with CL6 timing at 1.8 V. If the motherboard specifies this exact speed and voltage the kit will slot in and run at its rated settings without further adjustment.
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM DDR2 Orignial Desktop PC 240-Pin Non-ECC Unbuffered UDIMM Memory |
| Model | Original Series DDR2 Desktop PC Memory Solutions |
| Part Number | MD6400-228K4 |
| Capacity | 8GB (4 x 2GB) |
| Type | 240-Pin DDR2 UDIMM |
| Speed | DDR2 800 (PC2 6400) |
| CAS Latency | CL6 |
| Voltage | 1.80V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Heat Spreader | No |
| Features | DDR2 Non-ECC Unbuffered UDIMM Motherboard Compatible |
| LED Color | None |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
The kit uses the standard 240-pin DDR2 UDIMM form factor, so it fits any desktop board with DDR2 DIMM slots.
Open the retention clips, align the notch on each module with the slot key, press down firmly until both clips snap shut, then verify all four are fully latched.
DDR2 memory has no moving parts and no wear cycle; it typically runs for the life of the system unless physically damaged or a voltage fault occurs.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?