Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Rectangular ATX power supply unit, matte metal finish, label shows 12V 30A and 12V 1.0A outputs

KHACHIMO

KHACHIMO XL375-12 CS Power Supply V1 12V 30A V2 1.0A

SKU CH-48PH-70VSZ

Delivers 12 V at 30 A plus a 1.0 A auxiliary rail in an ATX form factor

  • TypeATX
  • Delivers 12 V at 30 A for high-current loads
  • Auxiliary 12 V at 1.0 A powers standby rails
  • ATX form factor fits standard chassis
  • Tested working and built with good quality components

ATX power module for industrial builds

This KHACHIMO XL375-12 CS power supply is an ATX-form-factor module rated for 375 W total output. It delivers a primary 12 V rail at 30 A and a secondary 12 V rail at 1.0 A. The unit is supplied new and has been tested working.

375 W capacity with dual 12 V rails

The 30 A main rail handles demanding 12 V loads such as GPU arrays or dense storage backplanes, while the 1.0 A auxiliary rail supports standby or management circuits. Builds requiring more than 375 W combined draw or additional voltage rails will need a higher-capacity or multi-rail solution.

Helstu kostir

  • Delivers 12 V at 30 A for high-current loads
  • Auxiliary 12 V at 1.0 A powers standby rails
  • ATX form factor fits standard chassis
  • Tested working and built with good quality components

Tæknilýsing

TypeATX

Spurningar um þessa vöru

Will the V1 12 V 30 A rail power my existing ATX motherboard and drives without adapters?

The module follows the ATX form factor and delivers 12 V at 30 A on the V1 rail, matching standard ATX 12 V requirements for motherboards and drives.

How can I verify the V2 12 V 1.0 A auxiliary output is live after installation?

Measure 12 V on the V2 pins with a multimeter while the unit is powered on; a reading near 12 V confirms the auxiliary rail is operating.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.