OWC 16GB DDR3 1600 ECC Registered RDIMM 2Rx4 1.5V 240-pin memory upgrade
- 16GB
- 240-Pin DDR3 ECC RD…
Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.
OWC
32 GB kit of four 8 GB DDR3-1600 ECC registered RDIMMs for Supermicro SuperWorkstation 5037A and 7047A systems
Capacity 32GB (4 x 8GB)
This 32GB kit contains four 8GB DDR3 1600 registered DIMMs built for Supermicro SuperWorkstation 5037A and 7047A systems. It delivers ECC error correction and registered buffering required by those platforms. Standard desktop motherboards cannot use this memory and it must not be mixed with unbuffered modules.
Modules operate at the JEDEC-standard 1.5V without heat spreaders, relying on chassis airflow for cooling. Registered buffering adds minimal latency at CL11 while maintaining signal integrity across all four slots. Power consumption follows DDR3 1600 specifications for registered DIMMs under typical workloads.
The kit replaces Supermicro part MEMDR380LSL04ER16 and is validated for the named workstation series only. Buyers needing unbuffered ECC or non-ECC memory for consumer platforms cannot use these modules. Each stick carries OWC's limited lifetime warranty with free technical support and advanced replacement service.
| Brand | OWC |
|---|---|
| Part Number | 1R6D31R4032S |
| Capacity | 32GB (4 x 8GB) |
| Type | 240-Pin DDR3 ECC RDIMM |
| Speed | DDR3 1600 (PC3 12800) |
| CAS Latency | CL11 |
| Voltage | 1.5V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 1Rx4 |
| Heat Spreader | No |
| Compatible System | Supermicro SuperWorkstation 5037A Series Supermicro SuperWorkstation 7047A Series |
Aðrar útgáfur af þessari vöru
Sama fjölskylda, mismunandi minni, kælingu eða klukkuhraða — berðu saman áður en þú ákveður þig.
Power down, open the chassis, align each 240-pin module with the slot key and press firmly until both retention clips lock; the step often missed is populating all four slots as a matched kit so the registered ECC timings remain identical across channels.
The modules have no heat spreaders and no moving parts, so only periodic dust removal from the DIMM slots and verification that the 1.5 V supply remains stable are required; replacement is only necessary if a module fails memory diagnostics.
The registered buffer and CL11 latency at 1600 MHz set the throughput ceiling, so memory bandwidth saturates before temperature or voltage become constraints on these bare DRAM modules.
Einnig í þessum vöruflokki
Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.
Það sem þú greiðir í, og það sem þú sérð verð í.
Sent úr veskinu þínu í greiðsluferlinu
Aðeins til skýringar — verð í vörulistanum eru í Bandaríkjadölum
Enginn gjaldmiðill passar við það.
Veldu tungumálið sem síðan talar við þig á.
Ekkert tungumál fannst.
Fyrsta heimsókn?
Áttu þegar aðgang?
Það er engin sjálfvirk endurstilling: þessi verslun sendir engan tölvupóst, svo það er enginn einnota tengill til að biðja um. Skildu netfangið eftir á aðganginum og einhver sinnir því handvirkt.
Beiðni skráð
Ekkert er á leiðinni í pósthólfið þitt — þessi verslun sendir engan tölvupóst. Einhver sinnir þessu handvirkt.
Mundir þú það?