OWC 16GB DDR3 1600 ECC Registered RDIMM 2Rx4 1.5V 240-pin memory upgrade
- 16GB
- 240-Pin DDR3 ECC RD…
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
OWC
32 GB kit of four 8 GB DDR3-1600 ECC registered RDIMMs for Supermicro SuperWorkstation 5037A and 7047A systems
Capacity 32GB (4 x 8GB)
This 32GB kit contains four 8GB DDR3 1600 registered DIMMs built for Supermicro SuperWorkstation 5037A and 7047A systems. It delivers ECC error correction and registered buffering required by those platforms. Standard desktop motherboards cannot use this memory and it must not be mixed with unbuffered modules.
Modules operate at the JEDEC-standard 1.5V without heat spreaders, relying on chassis airflow for cooling. Registered buffering adds minimal latency at CL11 while maintaining signal integrity across all four slots. Power consumption follows DDR3 1600 specifications for registered DIMMs under typical workloads.
The kit replaces Supermicro part MEMDR380LSL04ER16 and is validated for the named workstation series only. Buyers needing unbuffered ECC or non-ECC memory for consumer platforms cannot use these modules. Each stick carries OWC's limited lifetime warranty with free technical support and advanced replacement service.
| Brand | OWC |
|---|---|
| Part Number | 1R6D31R4032S |
| Capacity | 32GB (4 x 8GB) |
| Type | 240-Pin DDR3 ECC RDIMM |
| Speed | DDR3 1600 (PC3 12800) |
| CAS Latency | CL11 |
| Voltage | 1.5V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 1Rx4 |
| Heat Spreader | No |
| Compatible System | Supermicro SuperWorkstation 5037A Series Supermicro SuperWorkstation 7047A Series |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
Power down, open the chassis, align each 240-pin module with the slot key and press firmly until both retention clips lock; the step often missed is populating all four slots as a matched kit so the registered ECC timings remain identical across channels.
The modules have no heat spreaders and no moving parts, so only periodic dust removal from the DIMM slots and verification that the 1.5 V supply remains stable are required; replacement is only necessary if a module fails memory diagnostics.
The registered buffer and CL11 latency at 1600 MHz set the throughput ceiling, so memory bandwidth saturates before temperature or voltage become constraints on these bare DRAM modules.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?