NEMIX RAM
NEMIX RAM 192GB 4X48GB DDR5 6400MHz CL52 ECC RDIMM Supermicro H13SSL-N memory upgrade
A 192GB kit of four 48GB DDR5 6400MHz CL52 1.1V ECC registered RDIMMs validated for the Supermicro H13SSL-N motherboard
- Capacity192GB (4 x 48GB)
- Type288-Pin DDR5 RDIMM
- SpeedDDR5 6400 (PC5 51200)
- CAS LatencyCL52
- Voltage1.10V
- ECCYes
- 192 GB total capacity from four 48 GB modules
- DDR5 6400 speed with CL52 latency at 1.1 V
- ECC and registered design corrects errors and stabilises full loads
- 288-pin RDIMM form factor matches Supermicro H13SSL-N requirements
- Built with Samsung, Micron or Hynix chips for enterprise reliability
Exact-match server upgrade
This 192GB kit delivers four 48GB DDR5 6400 CL52 RDIMMs built to the Supermicro H13SSL-N motherboard's precise rank, voltage and timing requirements. Registered ECC architecture lets every slot run fully populated at rated speed while correcting single-bit errors on the fly. Modules arrive as a matched set with no heat spreader, ready for direct installation into 288-pin slots.
Thermals noise power
Operating at 1.1V, these low-voltage modules reduce per-DIMM power draw compared with higher-voltage DDR5 alternatives. The bare circuit design relies on server chassis airflow rather than integrated spreaders, keeping acoustic contribution negligible in typical rack environments. Registered buffering lightens the memory controller load, helping maintain stable thermals even with all slots populated.
What the kit changes
Population rules are satisfied in one purchase, eliminating trial-and-error mixing of loose sticks. ECC protection stops silent data corruption before it reaches production workloads, while registered signalling enables full-capacity operation across all channels. The matched 2Rx8 ranks ensure the board recognises the full 192GB at DDR5 6400 without manual timing adjustments.
Punti di forza
- 192 GB total capacity from four 48 GB modules
- DDR5 6400 speed with CL52 latency at 1.1 V
- ECC and registered design corrects errors and stabilises full loads
- 288-pin RDIMM form factor matches Supermicro H13SSL-N requirements
- Built with Samsung, Micron or Hynix chips for enterprise reliability
Caratteristiche tecniche
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM Original Series Server Memory |
| Model | DDR5 ECC RDIMM Registered Server Memory |
| Part Number | MR51200-4828K4 |
| Capacity | 192GB (4 x 48GB) |
| Type | 288-Pin DDR5 RDIMM |
| Speed | DDR5 6400 (PC5 51200) |
| CAS Latency | CL52 |
| Voltage | 1.10V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx8 |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Heat Spreader | No |
| Compatible System | Supermicro |
| Features | DDR5 ECC RDIMM Motherboard Compatible |
| Package Content | 192GB 4X48GB DDR5 6400MHz PC5-51200 2Rx8 1.1V 288-PIN ECC RDIMM KIT |
Domande su questo articolo
How do I install the four 48GB DDR5 RDIMM modules in the Supermicro H13SSL-N, and which step is most often missed?
Populate all four slots in the exact order shown in the motherboard manual; the step most often missed is verifying the required DIMM population sequence before powering on.
What maintenance or replacement will this 192GB DDR5 ECC RDIMM kit need later?
No scheduled maintenance is required; replacement is only necessary if a module fails, at which point the lifetime replacement warranty covers a new unit.
What limit appears first when the Supermicro H13SSL-N runs this 192GB DDR5 6400MHz kit under sustained load?
The memory controller's maximum supported capacity and population rules are the first limit; the kit matches the board's 288-pin RDIMM, 1.1V, CL52 spec so it runs at rated speed within those constraints.
Anche in questo reparto
Anche i clienti hanno confrontato questi
Stesso reparto, stessa cassa — otto monete e un cambio bloccato per 30 minuti.



