EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
Accettiamo criptovalute — così le crypto che Lei possiede possono comprare hardware reale.Paghi in crypto, la spenda in hardware reale. Spedizione assicurata gratuita in tutto il mondo oltre i 399 $. Cartoni neutri, senza marchio, spediti dalla Germania.Spedizione assicurata gratuita oltre i 399 $. Il Suo tasso resta bloccato per 30 minuti dall’apertura del checkout.Tasso bloccato 30 minuti. Ogni articolo è sigillato, il numero di serie è verificato, ed è coperto da una garanzia di 24 mesi.Sigillato, garantito 24 mesi.
OWC
A 64 GB DDR4 2666 ECC SODIMM kit for Synology DS723+ and DS923+ NAS units
This kit provides 64GB of DDR4 ECC memory in two 32GB SODIMM modules. It is built specifically for Synology DiskStation DS723+ and DS923+ NAS units. The modules run at 2666MHz with CL19 latency and 1.2V operation. Buyers who need a higher capacity than 64GB or a different form factor cannot use this kit.
The memory meets JEDEC and RoHS standards for a warranty-safe upgrade. It is backward compatible with 2400MHz and 2133MHz systems, allowing installation in platforms that run at those lower speeds. The kit includes no extra software, heat spreaders or cables; the value is in the validated compatibility and ECC error correction.
Each module uses a 260-pin unbuffered 2Rx8 layout without a heat spreader, keeping the profile low for tight NAS bays. The SODIMM form factor slots directly into the DiskStation memory sockets for a straightforward DIY installation. ECC support helps maintain data integrity during continuous operation.
| Brand | OWC |
|---|---|
| Part Number | 2C6D42R8064P |
| Capacity | 64GB (2 x 32GB) |
| Type | 260-Pin DDR4 ECC SODIMM |
| Speed | DDR4 2666 (PC4 21300) |
| CAS Latency | CL19 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | Synology DiskStation DS723+ Synology DiskStation DS923+ |
No firmware updates are required; the modules are JEDEC-standard 1.2V DDR4 2666 CL19 and the Synology NAS detects them automatically on boot.
The modules have no heat spreader, so the DRAM junction temperature reaches its JEDEC-rated maximum before the NAS chassis hits its thermal throttle point.
Each module runs at 1.2V DDR4 standard voltage; total kit draw rises by only a few watts over the factory 8GB configuration.
Anche in questo reparto
Stesso reparto, stessa cassa — otto monete e un cambio bloccato per 30 minuti.
Cosa invia per pagare, e in quale valuta legge i prezzi.
Inviato dal Suo portafoglio alla cassa
Solo a titolo indicativo — il catalogo è espresso in dollari
Nessuna valuta corrisponde.
Scelga la lingua in cui il sito Le parla.
Prima visita?
Ne ha già uno?
Non esiste un ripristino automatico: questo negozio non invia e-mail, quindi non esiste alcun link monouso da richiedere. Lasci l’indirizzo sull’account: verrà gestito manualmente.
Richiesta registrata
Non arriverà nulla nella Sua casella di posta — questo negozio non invia e-mail. Qualcuno se ne occupa manualmente.
L’ha ritrovata?