Kami menerima kripto — jadi koin yang anda simpan boleh membeli perkakasan sebenar.Bayar dengan kripto, belanjakannya untuk perkakasan sebenar. Penghantaran berinsurans percuma ke seluruh dunia untuk belian melebihi USD 399. Kotak biasa tanpa jenama, dihantar dari Jerman.Penghantaran berinsurans percuma untuk belian melebihi USD 399. Kadar anda dikunci selama 30 minit sebaik sahaja proses pesanan bermula.Kadar dikunci selama 30 minit. Setiap item disegel, nombor sirinya disemak, dan dilindungi waranti 24 bulan.Disegel, waranti 24 bulan.

Barang disimpan Log masuk
ATX power supply unit in metal casing with label showing voltage ratings

KHACHIMO

KHACHIMO WRA01X-C power supply +5V3A +12V0.5A -12V0.35A

SKU CH-GEHA-0WSG4

Delivers +5 V at 3 A, +12 V at 0.5 A and -12 V at 0.35 A for industrial medical equipment

  • TypeATX
  • Delivers +5 V at 3 A for reliable logic rail
  • Provides +12 V at 0.5 A to run auxiliary circuits
  • Supplies -12 V at 0.35 A for negative-rail needs
  • ATX form factor fits standard industrial and medical chassis

Industrial ATX Power Supply

The KHACHIMO WRA01X-C is an ATX form-factor unit built for industrial and medical equipment. It delivers regulated rails of +5V at 3A, +12V at 0.5A and -12V at 0.35A. Each unit is tested working before dispatch to confirm reliable operation in demanding environments.

Direct replacement for legacy ATX units

This supply fits existing ATX bays where the original unit has failed or drifted out of specification. The jump is worth it when equipment requires the specific +5V, +12V and -12V current ratings listed and a tested, good-quality replacement is needed to restore stable power.

Ciri-ciri utama

  • Delivers +5 V at 3 A for reliable logic rail
  • Provides +12 V at 0.5 A to run auxiliary circuits
  • Supplies -12 V at 0.35 A for negative-rail needs
  • ATX form factor fits standard industrial and medical chassis

Spesifikasi

TypeATX

Soalan tentang produk ini

Does this ATX power supply fit a standard ATX case mounting pattern?

Yes, the WRA01X-C follows the ATX form factor so it mounts in any standard ATX chassis using the usual four screw holes.

What is the correct way to connect the -12 V rail and what mistake should I avoid?

Wire the -12 V 0.35 A output only to circuits that require a negative rail; connecting it to a ground or 0 V point will cause a short.

Juga di rak ini

Pelanggan turut membandingkan

Rak yang sama, checkout yang sama — lapan koin kripto dan kunci kadar 30 minit.