Computer Memory Solutions 32GB (2x16GB) DDR4 2666 CL19 DIMM for Dell OptiPlex 7070 SFF Tower

Compatible 32GB kit for OptiPlex 7070 SFF and Tower

This 32GB kit contains two 16GB DDR4 modules rated at 2666MHz with CL19 timings. It is built specifically for Dell OptiPlex 7070 Small Form Factor and Tower desktops. The unbuffered non-ECC DIMMs install directly into the system's 288-pin slots. Buyers needing registered or ECC memory for server platforms cannot use this kit.

Low-voltage operation at 1.2V without heat spreaders

Each module runs at 1.20V, keeping power draw and heat output modest inside compact chassis. The absence of heat spreaders reduces vertical height, helping the sticks fit tight SFF clearances. Under normal workloads the memory operates silently with no active cooling required. Systems limited to lower memory voltages should verify compatibility before purchase.

Matched pair enables dual-channel throughput

The two sticks are packaged as a matched set so the platform can run in dual-channel mode, doubling memory bandwidth over a single module. Mixing these with existing modules of different speed or timing will force all memory to run at the slowest common settings. A 64-bit operating system is required to address the full 32GB capacity.