DELL
DELL 30FX3 7.68TB enterprise SSD
High-capacity enterprise SSD built for read-intensive data-centre workloads in compatible Dell PowerEdge servers
- InterfaceDoes Not Apply
- 68 TB capacity supports large data sets
- NVMe interface enables fast data transfer
- Designed for read-intensive enterprise workloads
- 5 inch 7 mm form factor fits standard bays
- Compatible with Dell PowerEdge R660, R760 and R960 servers
Dell 7.68TB NVMe Gen4 RI SSD
This Dell 30FX3 drive provides 7.68TB of read-intensive NVMe Gen4 storage in a 7mm 2.5-inch form factor. It uses TLC NAND and carries the PM9A3 controller for data-centre workloads. Components are tested and firmware is updated before shipment.
Suited for Dell PowerEdge servers needing
The drive fits PowerEdge models including R660, R760, R760XD2, R670, R770 and the MX760C compute sled. Buyers who require a different physical height, a write-intensive endurance rating or a non-NVMe interface should look at other parts.
7.68TB capacity in a 7mm 2.5-inch NVMe Gen4 package
This single specification determines whether the drive matches the bay and performance profile of the target server. Verify the slot height and backplane protocol against the system documentation before ordering.
Pluspunten
- 68 TB capacity supports large data sets
- NVMe interface enables fast data transfer
- Designed for read-intensive enterprise workloads
- 5 inch 7 mm form factor fits standard bays
- Compatible with Dell PowerEdge R660, R760 and R960 servers
Specificaties
| Brand | Dell |
|---|---|
| Model | 30FX3, MZQL27T6HBLA-00AD3 |
| Interface | Does Not Apply |
Vragen over dit artikel
What NVMe generation does the 30FX3 SSD use and what speed ceiling does that impose?
The drive runs on NVMe Gen4, so its maximum throughput is limited to the Gen4 PCIe lane rate.
Which drive bay and height does the 30FX3 require for mounting?
It fits a standard 2.5-inch bay and is 7 mm tall, matching the slim form factor used in the listed PowerEdge servers.
How is the 30FX3 installed in a compatible PowerEdge server and what step is often missed?
Slide the drive into the hot-swap tray until the connector seats firmly, then lock the tray latch; the step often missed is fully engaging the latch so the drive reports as present.
Ook in deze afdeling
Klanten vergeleken ook
Dezelfde afdeling, dezelfde kassa — acht munten en een koers die 30 minuten vaststaat.
