DELL
DELL 8TB 7.2K SATA 6.0Gb/s 512e 3.5" internal hard drive
Stores 8TB of enterprise data on a 3.5" SATA drive spinning at 7200 RPM with 6.0Gb/s transfer speed
- InterfaceSATA 6.0Gb/s
- Capacity8TB
- RPM7200 RPM
- Form Factor3.5"
- 8 TB capacity stores large enterprise data sets
- 7200 RPM spindle speed delivers strong sequential performance
- SATA 6.0 Gb/s interface provides high transfer rates
- 5 inch LFF form factor fits compatible server bays
- Designed for 13th generation PowerEdge R430 R530 R730 R730XD T430 T630
8TB SATA desktop drive for enterprise servers
This 8TB 3.5" internal hard drive uses a SATA 6.0Gb/s interface and spins at 7200 RPM. It is built for Dell 13th Generation PowerEdge servers including R430, R530, R730, R730XD, T430 and T630 systems. The 512e format supports large-capacity storage in compatible bays.
Suits administrators expanding 13th Generation
IT teams adding bulk capacity to listed Dell servers will find the correct form factor and interface here. Buyers needing a different drive interface or a 2.5" form factor cannot use this unit. Systems outside the supported model list should verify compatibility before purchase.
SATA 6.0Gb/s interface determines host compatibility
The drive connects exclusively through a SATA 6.0Gb/s port. Controllers or backplanes limited to other interfaces will not accept this device. Confirm the server bay and controller support SATA at 6.0Gb/s before installation.
Pluspunten
- 8 TB capacity stores large enterprise data sets
- 7200 RPM spindle speed delivers strong sequential performance
- SATA 6.0 Gb/s interface provides high transfer rates
- 5 inch LFF form factor fits compatible server bays
- Designed for 13th generation PowerEdge R430 R530 R730 R730XD T430 T630
Specificaties
| Interface | SATA 6.0Gb/s |
|---|---|
| Capacity | 8TB |
| RPM | 7200 RPM |
| Form Factor | 3.5" |
Vragen over dit artikel
What server bays accept this 3.5" drive?
The 3.5" form factor fits large-form-factor bays in PowerEdge R430, R530, R730, R730XD, T430 and T630 servers.
Which step is often missed when installing the drive in a 13th Generation PowerEdge?
Insert the drive into the hot-plug carrier until the latch clicks, then verify the controller recognises the 512e sector format before initialising the volume.
When should the 8TB 7200 RPM drive be replaced in a RAID array?
Replace it if SMART reports reallocated sectors, the array logs predictive-failure alerts, or sustained throughput drops below the expected SATA 6.0Gb/s rate.
Ook in deze afdeling
Klanten vergeleken ook
Dezelfde afdeling, dezelfde kassa — acht munten en een koers die 30 minuten vaststaat.
