Wij accepteren cryptovaluta — zo kunnen de munten die u bezit echte hardware kopen.Betaal in crypto, besteed het aan echte hardware. Gratis verzekerde verzending wereldwijd vanaf $399. Neutrale dozen zonder merk, verzonden vanuit Duitsland.Gratis verzekerde verzending vanaf $399. Uw koers wordt 30 minuten vastgezet zodra het afrekenen begint.Koers 30 minuten vastgezet. Elk artikel is verzegeld, het serienummer wordt gecontroleerd, en het valt onder 24 maanden garantie.Verzegeld, 24 maanden garantie.

Favoriete artikelen Inloggen
Black 60mm square cooling fan with three-wire connector

OEM Industries

OEM Industries 2410ML-04W-B39 60mm Ball Bearing Fan

SKU CH-TNWP-AT8V1

60mm ball-bearing CPU fan runs at 12V drawing 0.16A via a 3-pin connector

  • ColorBlack
  • TypeFan only
  • Fan Size60mm
  • Bearing TypeBall
  • Power Connector3 Pin
  • LEDNo
  • Reliable long-life operation with dual ball bearing design
  • Low power draw at 12 V and 0.16 A current
  • Standard 60 mm frame fits common mounting points
  • Three-pin connector enables speed monitoring and control
  • Compact 25 mm thickness suits tight chassis spaces

Genuine NMB-MAT 60 mm Ball Bearing Fan

This original NMB-MAT 2410ML-04W-B39 is a 6025 frame DC cooling fan built with dual ball bearings for long service life. It runs on 12 V at 0.16 A and connects through a standard three-pin power header. The unit ships new in black without any LED lighting.

For Compact 12 V Cooling Replacements

It suits technicians who need a direct 60 mm drop-in for small-form-factor CPU coolers, industrial enclosures or legacy hardware that uses a three-pin header. Builders who require PWM speed control, larger airflow or a four-pin connector should look at other models.

Three-Pin 12 V Power Connector

The fan draws 0.16 A from a 12 V three-pin header and provides no PWM signal wire. Verify that your board or controller supplies a compatible three-pin 12 V output before ordering.

Pluspunten

  • Reliable long-life operation with dual ball bearing design
  • Low power draw at 12 V and 0.16 A current
  • Standard 60 mm frame fits common mounting points
  • Three-pin connector enables speed monitoring and control
  • Compact 25 mm thickness suits tight chassis spaces

Specificaties

Model2410ML-04W-B39
ColorBlack
TypeFan only
Fan Size60mm
Bearing TypeBall
Power Connector3 Pin
LEDNo

Vragen over dit artikel

How do I install the 60mm ball bearing fan using the 3-pin power connector and what step do people often miss?

Align the four mounting holes on the 60x60x25mm frame, secure with screws, then plug the 3-pin connector into a 12V header; the step often missed is checking that the tachometer wire seats fully so speed reporting works.

What maintenance or replacement will the 2410ML-04W-B39 need later?

The dual ball bearings are rated for long life, but dust buildup on the blades reduces airflow; clean with compressed air every few months and replace the fan if bearing noise appears or rpm drops below spec.

What limit shows up first on the 12V 0.16A fan under sustained use?

The 0.16A current draw at 12V sets the thermal ceiling; if case airflow is restricted the motor hits its temperature limit first, causing rpm to throttle or the bearing to wear faster.

Ook in deze afdeling

Klanten vergeleken ook

Dezelfde afdeling, dezelfde kassa — acht munten en een koers die 30 minuten vaststaat.