Zyvpee
Zyvpee AFC0712DB 70x15mm 4-pin 12V .45A case fan
70 mm ball-bearing case fan with 4-pin 12 V .45 A connector for CPU cooling
- TypeCase Fan
- Bearing TypeBall
- Power Connector4 Pin
- ColorBlack
- LEDNon-LED
- Featurescpu cooling
- Ball bearing ensures long-term reliability
- 12 V 0.45 A 4-pin PWM enables precise speed control
- Compact 70 x 15 mm fits tight chassis spaces
- Non-LED black design keeps builds clean
- Delta-built AFC0712DB engineered for CPU cooling
70 mm ball-bearing case fan
The Zyvpee AFC0712DB is a 70 by 15 millimetre case fan that runs on 12 volts and draws 0.45 amps. It uses a four-pin power connector for PWM speed control and features a ball bearing for long service life. The black frame carries no LED lighting, making it suitable for builds that prefer a subtle look.
Suits compact CPU coolers and tight chassis
This fan fits 70 millimetre mounting points commonly found on small-form-factor CPU coolers or restricted case locations. Buyers who need larger airflow volumes, RGB illumination or a different mounting pattern should look at other sizes or series.
Verify 70 mm mounting holes and four-pin header
Before ordering, confirm that your cooler or case has 70 millimetre screw spacing and that your motherboard or fan controller provides a four-pin PWM header. The fan operates at 12 volts, so the header must supply that voltage.
Pluspunten
- Ball bearing ensures long-term reliability
- 12 V 0.45 A 4-pin PWM enables precise speed control
- Compact 70 x 15 mm fits tight chassis spaces
- Non-LED black design keeps builds clean
- Delta-built AFC0712DB engineered for CPU cooling
Specificaties
| Brand | 3ccooler.com |
|---|---|
| Series | AFC0712DB -6M14 |
| Model | AFC0712DB |
| Type | Case Fan |
| Bearing Type | Ball |
| Power Connector | 4 Pin |
| Color | Black |
| LED | Non-LED |
| Features | cpu cooling |
| Dimensions | 70*15mm |
Vragen over dit artikel
Does my motherboard need a 4-pin PWM header to run the AFC0712DB at 12 V?
Yes, the fan uses a standard 4-pin connector that plugs directly into a 12 V PWM header on the board.
Will the 70 mm frame and 15 mm thickness fit the same mounting holes as my old 7015 fan?
The 70×15 mm dimensions match the common 7015 footprint, so existing screw holes line up without modification.
How can I confirm the ball-bearing fan is spinning at the correct speed after installation?
Check the RPM reading in BIOS or monitoring software; it should report a stable value once the 4-pin PWM signal is active.
Ook in deze afdeling
Klanten vergeleken ook
Dezelfde afdeling, dezelfde kassa — acht munten en een koers die 30 minuten vaststaat.
ModMyMods
ModMyMods MOD-0002 3/8" ID x 1/2" OD Clear PVC Tubing DIY Cooling
- Clear
US$ 0,82
0.00001051BTC
Op voorraad