Acceptăm criptomonede — astfel, criptomonedele pe care le dețineți pot cumpăra echipamente reale.Plătiți în cripto, cheltuiți-o pe echipamente reale. Livrare asigurată gratuită oriunde în lume peste 399 $. Cartoane neutre, fără marcă, expediate din Germania.Livrare asigurată gratuită peste 399 $. Cursul dumneavoastră este blocat timp de 30 de minute de la deschiderea paginii de plată.Curs blocat 30 de minute. Fiecare articol este sigilat, numărul de serie este verificat, iar produsul este acoperit de o garanție de 24 de luni.Sigilat, garantat 24 de luni.

Produse urmărite Conectare
Two green DDR3 DIMM sticks with gold contacts, sold as a 16GB kit

Computer Memory Solutions

Computer Memory Solutions 16GB (2x8GB) DDR3 1600 ECC Non-Registered DIMM memory upgrade

SKU CH-RSH9-HAYMC

Dual-channel 16 GB DDR3 1600 ECC kit for HP Z1 All-in-One workstations

  • Capacity16GB (2 x 8GB)
  • Type240-Pin DDR3 SDRAM
  • SpeedDDR3 1600 (PC3 12800)
  • CAS LatencyCL11
  • Timing11-11-11
  • Voltage1.5V
  • 16 GB kit (2 × 8 GB) expands workstation capacity
  • DDR3-1600 speed with CL11 timing for responsive performance
  • ECC unregistered DIMMs protect data integrity in critical tasks
  • Validated for HP Z1 All-in-One workstations
  • 5 V operation matches standard DDR3 voltage requirements

HP Z1 All-in-One 16 GB kit

This 16 GB kit contains two 8 GB DDR3 ECC non-registered DIMMs built for the HP Compaq Workstation Z1 All-in-One. Each module runs at 1600 MHz with CL11 timing at 1.5 V. The 240-pin design matches the system's four memory slots. Computer Memory Solutions guarantees compatibility with the listed Z1 models.

For Z1 owners needing ECC memory

The kit suits owners of B2B85UT or B2B84UT Z1 workstations who want the full 16 GB ECC capacity in matched pairs for dual-channel operation. Buyers whose Z1 runs a Core i5 or i7 processor cannot use ECC modules; those systems only accept non-ECC memory. Mixing ECC with non-ECC is not supported on this platform.

Must install in matched pairs

The Z1 requires modules to be ordered and installed in pairs to enable dual-channel mode. This 2 x 8 GB kit satisfies that rule and delivers the maximum 16 GB ECC unbuffered capacity the system recognises. A 64-bit operating system is required to address the full amount.

Puncte forte

  • 16 GB kit (2 × 8 GB) expands workstation capacity
  • DDR3-1600 speed with CL11 timing for responsive performance
  • ECC unregistered DIMMs protect data integrity in critical tasks
  • Validated for HP Z1 All-in-One workstations
  • 5 V operation matches standard DDR3 voltage requirements

Specificații

BrandComputer Memory Solutions
ModelCM10247212800ECCNRDIMM2R8
Capacity16GB (2 x 8GB)
Type240-Pin DDR3 SDRAM
SpeedDDR3 1600 (PC3 12800)
CAS LatencyCL11
Timing11-11-11
Voltage1.5V
ECCYes
Buffered/RegisteredUnregistered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderBased on Current Inventory (If Required Please Contact)
Compatible SystemHp/Compaq Workstation Z1 All In One
Package Content2 Memory RAM Sticks

Întrebări despre acest articol

Does the DDR3-1600 (PC3-12800) interface limit the modules to 1600 MHz even if the workstation supports higher speeds?

Yes, the kit is rated for DDR3-1600 (PC3-12800) and will run at that speed; the system will not exceed the module rating.

Will these 240-pin DIMMs fit the HP/Compaq Workstation Z1 All-in-One, and how many slots does that system provide?

The 240-pin form factor matches the Z1 All-in-One, which has four memory sockets for dual-channel pairs.

The spec sheet says modules must be installed in pairs — which slots should the two 8 GB sticks occupy for dual-channel operation?

Populate the two slots of the same channel pair (typically slots 1 and 3 or 2 and 4) so the kit runs in dual-channel mode.

Tot din acest raion

Clienții au comparat și acestea.

Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.