NEMIX RAM MR44800-724K2 256GB (2x128GB) DDR5 5600 ECC RDIMM memory upgrade

Exact DDR5-5600 RDIMM kit for GIGABYTE MS34-CP0

This 256GB kit delivers two 128GB DDR5 registered ECC modules rated at 5600 MT/s with CL46 latency and 1.10V operation. It is built for the GIGABYTE MS34-CP0 motherboard where the memory controller expects 2Rx4 registered DIMMs at this exact speed and voltage. The matching rank structure and timing allow the server to recognise the full 256GB capacity and run at the rated data rate without downclocking.

288-pin RDIMM installation follows the board manual

Each module uses the standard 288-pin DDR5 RDIMM form factor with registered buffering and ECC, so it seats only in slots wired for registered memory. The motherboard manual specifies the supported population order and maximum capacity per channel; deviating from that order is the most common reason the system fails to POST or shows reduced capacity. Verify the approved slot sequence before inserting the pair and ensure the latches engage fully on both sides.

Registered ECC design sustains full-speed operation

The registered architecture buffers address and command signals, reducing electrical load on the memory controller when all slots are populated. Combined with on-die ECC, this allows the kit to maintain 5600 MT/s throughput continuously under heavy multi-threaded workloads without accumulating correctable errors that would otherwise trigger throttling or corrective resets. The 1.10V operating voltage remains stable during extended runs, supporting consistent bandwidth for virtualisation, database, and compute tasks.