Acceptăm criptomonede — astfel, criptomonedele pe care le dețineți pot cumpăra echipamente reale.Plătiți în cripto, cheltuiți-o pe echipamente reale. Livrare asigurată gratuită oriunde în lume peste 399 $. Cartoane neutre, fără marcă, expediate din Germania.Livrare asigurată gratuită peste 399 $. Cursul dumneavoastră este blocat timp de 30 de minute de la deschiderea paginii de plată.Curs blocat 30 de minute. Fiecare articol este sigilat, numărul de serie este verificat, iar produsul este acoperit de o garanție de 24 de luni.Sigilat, garantat 24 de luni.

Produse urmărite Conectare
Green rectangular circuit board with gold edge connector and black memory chips

OWC

OWC 4GB DDR3 1333 CL9 1.5V 204-pin SODIMM memory upgrade

SKU CH-MBNB-RE0S5

A single 4GB DDR3 1333 CL9 1.5V SODIMM module for HP ProBook 4230s, 4310s, 4320s, 4325s and 4326s laptops

  • Capacity4GB
  • Type204-Pin DDR3 Non-ECC SODIMM
  • SpeedDDR3 1333 (PC3 10600)
  • CAS LatencyCL9
  • Voltage1.5V
  • ECCNo
  • Boosts multitasking with 4GB DDR3 1333MHz CL9 SODIMM
  • Fits HP ProBook 4230s 4310s 4320s 4325s 4326s
  • JEDEC and RoHS compliant for warranty-safe upgrades
  • Simple DIY install with 204-pin unbuffered design
  • Lifetime warranty backed by OWC tech support

Single-module 4 GB DDR3 SODIMM

This 204-pin DDR3 module delivers 4 GB at 1333 MHz with CL9 latency and 1.5 V operation. It is built to JEDEC and RoHS standards and validated for the HP ProBook 4230s, 4310s, 4320s, 4325s and 4326s. The unbuffered, non-ECC design installs without tools in most compatible notebooks.

Suits owners of listed ProBooks needing

Builders who require ECC, registered DIMMs, a different voltage or a higher capacity per module should look elsewhere. Systems that only accept 1.35 V low-voltage DDR3 cannot use this stick. The 2Rx8 rank layout may not work in platforms limited to single-rank modules.

2Rx8 rank configuration

The module uses a dual-rank 2Rx8 organisation, which determines whether the memory controller can address the full 4 GB. Check the service manual for your specific ProBook model to confirm dual-rank support before purchase.

Puncte forte

  • Boosts multitasking with 4GB DDR3 1333MHz CL9 SODIMM
  • Fits HP ProBook 4230s 4310s 4320s 4325s 4326s
  • JEDEC and RoHS compliant for warranty-safe upgrades
  • Simple DIY install with 204-pin unbuffered design
  • Lifetime warranty backed by OWC tech support

Specificații

BrandOWC
Part Number1S3D32R804GB
Capacity4GB
Type204-Pin DDR3 Non-ECC SODIMM
SpeedDDR3 1333 (PC3 10600)
CAS LatencyCL9
Voltage1.5V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
Heat SpreaderNo
Compatible SystemHP ProBook 4230s
HP ProBook 4310s
HP ProBook 4320s
HP ProBook 4325s
HP ProBook 4326s

Alte versiuni ale acestui model

5 în plus din aceeași gamă

Aceeași familie, memorie, radiator sau frecvență diferite — comparați înainte de a vă decide.

Întrebări despre acest articol

Which HP ProBook models must I own for this 204-pin DDR3 1333 CL9 SODIMM to be compatible?

The module is validated for HP ProBook 4230s, 4310s, 4320s, 4325s and 4326s, so one of those laptops is required for a supported installation.

Will this 1.5 V PC3-10600 module work alongside the original memory already in my ProBook?

Yes, it is an unbuffered non-ECC DDR3 SODIMM at the same voltage and speed, so it can run in dual-channel with the factory-installed sticks.

How can I confirm the 4 GB upgrade is running at DDR3 1333 CL9 after installation?

Open Task Manager or a system-information utility and verify the memory speed shows 1333 MHz with CAS latency 9 for the new module.

Tot din acest raion

Clienții au comparat și acestea.

Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.