Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Green rectangular circuit board with gold edge connector and black memory chips

OWC

OWC 4GB DDR3 1333 CL9 1.5V 204-pin SODIMM memory upgrade

SKU CH-MBNB-RE0S5

A single 4GB DDR3 1333 CL9 1.5V SODIMM module for HP ProBook 4230s, 4310s, 4320s, 4325s and 4326s laptops

  • Capacity4GB
  • Type204-Pin DDR3 Non-ECC SODIMM
  • SpeedDDR3 1333 (PC3 10600)
  • CAS LatencyCL9
  • Voltage1.5V
  • ECCNo
  • Boosts multitasking with 4GB DDR3 1333MHz CL9 SODIMM
  • Fits HP ProBook 4230s 4310s 4320s 4325s 4326s
  • JEDEC and RoHS compliant for warranty-safe upgrades
  • Simple DIY install with 204-pin unbuffered design
  • Lifetime warranty backed by OWC tech support

Single-module 4 GB DDR3 SODIMM

This 204-pin DDR3 module delivers 4 GB at 1333 MHz with CL9 latency and 1.5 V operation. It is built to JEDEC and RoHS standards and validated for the HP ProBook 4230s, 4310s, 4320s, 4325s and 4326s. The unbuffered, non-ECC design installs without tools in most compatible notebooks.

Suits owners of listed ProBooks needing

Builders who require ECC, registered DIMMs, a different voltage or a higher capacity per module should look elsewhere. Systems that only accept 1.35 V low-voltage DDR3 cannot use this stick. The 2Rx8 rank layout may not work in platforms limited to single-rank modules.

2Rx8 rank configuration

The module uses a dual-rank 2Rx8 organisation, which determines whether the memory controller can address the full 4 GB. Check the service manual for your specific ProBook model to confirm dual-rank support before purchase.

Přednosti

  • Boosts multitasking with 4GB DDR3 1333MHz CL9 SODIMM
  • Fits HP ProBook 4230s 4310s 4320s 4325s 4326s
  • JEDEC and RoHS compliant for warranty-safe upgrades
  • Simple DIY install with 204-pin unbuffered design
  • Lifetime warranty backed by OWC tech support

Specifikace

BrandOWC
Part Number1S3D32R804GB
Capacity4GB
Type204-Pin DDR3 Non-ECC SODIMM
SpeedDDR3 1333 (PC3 10600)
CAS LatencyCL9
Voltage1.5V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
Heat SpreaderNo
Compatible SystemHP ProBook 4230s
HP ProBook 4310s
HP ProBook 4320s
HP ProBook 4325s
HP ProBook 4326s

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

Which HP ProBook models must I own for this 204-pin DDR3 1333 CL9 SODIMM to be compatible?

The module is validated for HP ProBook 4230s, 4310s, 4320s, 4325s and 4326s, so one of those laptops is required for a supported installation.

Will this 1.5 V PC3-10600 module work alongside the original memory already in my ProBook?

Yes, it is an unbuffered non-ECC DDR3 SODIMM at the same voltage and speed, so it can run in dual-channel with the factory-installed sticks.

How can I confirm the 4 GB upgrade is running at DDR3 1333 CL9 after installation?

Open Task Manager or a system-information utility and verify the memory speed shows 1333 MHz with CAS latency 9 for the new module.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.