Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.

Sledované položky Prihlásiť sa
Grey metal ATX power supply, reduced depth, single fan, 2.5 kg

Gulfe

Gulfe ATX Power Supply 5.9" Depth 2.5kg 1 Fan

SKU CH-8076-BNTNT

Replacement ATX power supply with reduced 5.9 inch depth, single fan and 2.5 kg weight, delivering +5V, +12V1, +12V2, +3.3V, -12V and +5V-SB rails with over-current and over-power protection

  • TypeATX
  • Fans1
  • Weight2.5
  • ATX form factor fits standard cases
  • Reduced 5.9" depth improves compatibility with tight chassis
  • 24-pin ATX, 4-pin P4, 3 SATA, 2 LP4 and 1 floppy connectors included
  • Over-current and over-power protection safeguards components
  • 115/230 V input with 17 ms hold-up time at nominal load

Compatible Replacement Unit

This ATX power supply is built as a direct replacement for HP Pavilion Elite M9200Z and M9250F desktop systems. It delivers the standard output rails including +5V, -5V, +12V1, +12V2, +3.3V, -12V and +5V-SB. The unit weighs 2.5 kg and operates on 115 or 230 V input.

Suits Legacy HP Builds Only

The reduced depth of 5.9 inches and 3.4 inch width fits the specific chassis of the named Pavilion models. It is not suitable for standard ATX cases that require full-length units or for systems needing higher wattage than this legacy design provides. Builders upgrading modern components should look elsewhere.

Connector Kit Covers Legacy Needs

The bundle includes one 24-pin ATX connector, one 4-pin P4-12V connector, three SATA 15-pin connectors, two LP4 4-pin connectors and one floppy 4-pin connector. This selection matches the original motherboard and drive complement of the target desktops without requiring adapters.

Prednosti

  • ATX form factor fits standard cases
  • Reduced 5.9" depth improves compatibility with tight chassis
  • 24-pin ATX, 4-pin P4, 3 SATA, 2 LP4 and 1 floppy connectors included
  • Over-current and over-power protection safeguards components
  • 115/230 V input with 17 ms hold-up time at nominal load

Špecifikácie

BrandGulfe
TypeATX
Fans1
Weight2.5

Otázky k tomuto produktu

Does my HP Pavilion Elite M9200Z or M9250F desktop already have the ATX 24-pin and P4 4-pin connectors this supply uses?

Yes — the unit ships with an ATX 24 (20+4) pin connector and a P4 12 V 4-pin connector that match the motherboard sockets in those models.

Will the reduced 5.9-inch depth fit alongside the existing drive cages in my M9200Z chassis?

The shorter 5.86-inch depth leaves extra clearance behind the drive bays, so the supply slides in without fouling the cages.

How can I confirm the +12 V rails are delivering stable power after I install it?

Measure the +12 V1 and +12 V2 outputs with a multimeter under load; they should stay within spec with ripple and noise kept low by the Hi-Pot tested design.

Aj v tomto oddelení

Zákazníci tiež porovnávali

Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.