Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Grey metal ATX power supply, reduced depth, single fan, 2.5 kg

Gulfe

Gulfe ATX Power Supply 5.9" Depth 2.5kg 1 Fan

SKU CH-8076-BNTNT

Replacement ATX power supply with reduced 5.9 inch depth, single fan and 2.5 kg weight, delivering +5V, +12V1, +12V2, +3.3V, -12V and +5V-SB rails with over-current and over-power protection

  • TypeATX
  • Fans1
  • Weight2.5
  • ATX form factor fits standard cases
  • Reduced 5.9" depth improves compatibility with tight chassis
  • 24-pin ATX, 4-pin P4, 3 SATA, 2 LP4 and 1 floppy connectors included
  • Over-current and over-power protection safeguards components
  • 115/230 V input with 17 ms hold-up time at nominal load

Compatible Replacement Unit

This ATX power supply is built as a direct replacement for HP Pavilion Elite M9200Z and M9250F desktop systems. It delivers the standard output rails including +5V, -5V, +12V1, +12V2, +3.3V, -12V and +5V-SB. The unit weighs 2.5 kg and operates on 115 or 230 V input.

Suits Legacy HP Builds Only

The reduced depth of 5.9 inches and 3.4 inch width fits the specific chassis of the named Pavilion models. It is not suitable for standard ATX cases that require full-length units or for systems needing higher wattage than this legacy design provides. Builders upgrading modern components should look elsewhere.

Connector Kit Covers Legacy Needs

The bundle includes one 24-pin ATX connector, one 4-pin P4-12V connector, three SATA 15-pin connectors, two LP4 4-pin connectors and one floppy 4-pin connector. This selection matches the original motherboard and drive complement of the target desktops without requiring adapters.

Přednosti

  • ATX form factor fits standard cases
  • Reduced 5.9" depth improves compatibility with tight chassis
  • 24-pin ATX, 4-pin P4, 3 SATA, 2 LP4 and 1 floppy connectors included
  • Over-current and over-power protection safeguards components
  • 115/230 V input with 17 ms hold-up time at nominal load

Specifikace

BrandGulfe
TypeATX
Fans1
Weight2.5

Otázky k tomuto produktu

Does my HP Pavilion Elite M9200Z or M9250F desktop already have the ATX 24-pin and P4 4-pin connectors this supply uses?

Yes — the unit ships with an ATX 24 (20+4) pin connector and a P4 12 V 4-pin connector that match the motherboard sockets in those models.

Will the reduced 5.9-inch depth fit alongside the existing drive cages in my M9200Z chassis?

The shorter 5.86-inch depth leaves extra clearance behind the drive bays, so the supply slides in without fouling the cages.

How can I confirm the +12 V rails are delivering stable power after I install it?

Measure the +12 V1 and +12 V2 outputs with a multimeter under load; they should stay within spec with ripple and noise kept low by the Hi-Pot tested design.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.