Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.

Sledované položky Prihlásiť sa
Two green DDR3 ECC registered DIMMs, 240-pin, no heat spreaders

OWC

OWC 16GB 2x8GB DDR3 1333 ECC RDIMM PowerVault NX300 NX3000

SKU CH-X87E-17N8A

16 GB dual-channel DDR3 1333 ECC registered kit for Dell PowerVault NX300 and NX3000 servers

  • Capacity16GB (2 x 8GB)
  • Type240-Pin DDR3 ECC RDIMM
  • SpeedDDR3 1333 (PC3 10600)
  • CAS LatencyCL9
  • Voltage1.5V
  • ECCYes

Capacity 16GB (2 x 8GB)

  • 16GB dual-module kit doubles server memory capacity
  • DDR3 1333 CL9 speed matches Dell PowerVault NX300 and NX3000 specifications
  • ECC registered design prevents data errors in critical workloads
  • 5V 240-pin RDIMM form factor fits validated Dell part numbers
  • Two 8GB 2Rx4 modules enable straightforward capacity expansion

System-Specific DDR3 ECC RDIMM Kit

This OWC kit provides 16 GB of DDR3 1333 registered ECC memory in a matched pair of 8 GB modules. It is designed for Dell PowerVault NX300 and NX3000 storage servers that require 240-pin DDR3 RDIMMs. The modules operate at 1.5 V with CL9 latency and a 2Rx4 organisation. They are not compatible with standard desktop or consumer laptop platforms.

Compatibility Check Before Ordering

Verify that your target system is a Dell PowerVault NX300 or NX3000 and that it accepts registered ECC DDR3 RDIMMs. Unbuffered or non-ECC modules will not work in these servers and mixing registered with unbuffered memory is unsupported. Confirm the platform has available 240-pin DIMM slots and that the BIOS or firmware supports the full 16 GB capacity across two slots.

Build Quality and Daily Use

Each module uses a standard 240-pin DDR3 PCB without a heat spreader, relying on server chassis airflow for cooling. The registered design adds a buffer that reduces electrical load on the memory controller, improving stability in multi-DIMM configurations. Installation follows the usual DIMM ejection-lever procedure; no special tools or cables are required beyond opening the server chassis.

Prednosti

  • 16GB dual-module kit doubles server memory capacity
  • DDR3 1333 CL9 speed matches Dell PowerVault NX300 and NX3000 specifications
  • ECC registered design prevents data errors in critical workloads
  • 5V 240-pin RDIMM form factor fits validated Dell part numbers
  • Two 8GB 2Rx4 modules enable straightforward capacity expansion

Špecifikácie

BrandOWC
Part Number1R3D32R4016P
Capacity16GB (2 x 8GB)
Type240-Pin DDR3 ECC RDIMM
SpeedDDR3 1333 (PC3 10600)
CAS LatencyCL9
Voltage1.5V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
Heat SpreaderNo
Compatible SystemDell PowerVault NX300
Dell PowerVault NX3000

Ďalšie verzie tohto modelu

Ďalších 5 v tomto rade

Rovnaký rad, iná pamäť, chladič alebo frekvencia — porovnajte pred rozhodnutím.

Otázky k tomuto produktu

Does the 16GB kit include both 8GB modules or must I buy a second kit?

The kit contains two 8GB modules for a total of 16GB, so no additional purchase is required.

Should I choose the 2Rx4 registered ECC version or an unbuffered alternative for my PowerVault NX3000?

The NX3000 requires registered ECC memory; unbuffered modules will not work in this system.

Will the DDR3 1333 CL9 modules run at their rated 1333MHz speed once installed in the PowerVault NX300?

Yes, the modules operate at DDR3 1333 (PC3-10600) with CL9 latency when installed in compatible PowerVault systems.

Aj v tomto oddelení

Zákazníci tiež porovnávali

Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.