LONGER
LONGER RAY5 20W Laser Engraver & Honeycomb Working Table 500mm
A 20 W laser engraver with a 500 mm honeycomb table for clean cutting and engraving
Option 20W+500*500
- 20W+500*500
- 20W+Air Assist kit
- 20w + 8 Pcs Riser Pads
- 20W+Roller Kits
- 20W+Rotary Roller
- 20W+Lightbum Camera
- 20W+Laser Engrave Enclosure
- 20W+Material Pack
- 20W+200*300
- 20W+400*400
- 20W+Y-Axis Expansion Kit
- 20W+Aluminum Cards 100 PCS
Prikaži še 1 konfiguracij
- 20 W laser power for deep cutting on wood and acrylic
- 500 mm square honeycomb table gives stable, smoke-free support
- 7 inch work area fits large panels in one pass
- Integrated honeycomb design removes debris for cleaner edges
LONGER RAY5 20W laser engraver with honeycomb table
The LONGER RAY5 20W laser engraver ships with a honeycomb working table measuring 500mm by 500mm. This combination targets makers and hobbyists who need a ready-to-use cutting and marking system. The 20W optical output handles wood, acrylic, leather and similar sheet materials. Buyers who require a fully enclosed safety cabinet or an integrated air-assist pump should look elsewhere.
Thermals, noise and power draw
The open-frame design relies on passive airflow across the laser module and stepper drivers during operation. Fan noise from the module is audible but stays at a moderate level for a desktop workshop. Power consumption scales with the 20W laser output and motion system, drawing a steady load from the supplied adapter. No liquid cooling or active enclosure ventilation is included.
Poudarki
- 20 W laser power for deep cutting on wood and acrylic
- 500 mm square honeycomb table gives stable, smoke-free support
- 7 inch work area fits large panels in one pass
- Integrated honeycomb design removes debris for cleaner edges
Specifikacije
Za ta izdelek še ni objavljenih specifikacij.
Druge različice tega modela
še 5 v isti paleti
Ista družina, različen pomnilnik, hladilnik ali takt — primerjajte, preden se odločite.
Vprašanja o tem izdelku
How do I install the 500mm honeycomb working table with the 20W laser engraver?
Place the honeycomb table on the machine base, align it with the frame edges, then secure it using the provided mounting brackets before connecting the engraver.
What maintenance will the 20W laser module need over time?
Clean the lens with isopropyl alcohol weekly, check the air-assist nozzle for residue, and replace the diode when cutting depth noticeably decreases.
Tudi v tem oddelku
Stranke so primerjale tudi te
Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.
