NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Sprejemamo kriptovalute — tako lahko sredstva, ki jih imate, kupijo pravo strojno opremo.Plačajte v kriptovaluti, zapravite jo za pravo strojno opremo. Brezplačna zavarovana dostava po vsem svetu nad 399 $. Nevtralni kartoni brez znamke, poslani iz Nemčije.Brezplačna zavarovana dostava nad 399 $. Vaš tečaj je zaklenjen za 30 minut, takoj ko se odpre blagajna.Tečaj zaklenjen 30 minut. Vsak izdelek je zapečaten, njegova serijska številka preverjena, in krit z 24-mesečno garancijo.Zapečateno, 24-mesečna garancija.
OWC
128GB DDR4 2933MHz ECC load-reduced DIMM for servers and workstations, 288-pin CL21 1.2V module compatible with Fujitsu part numbers
This module is a 128GB DDR4 2933 ECC load-reduced DIMM built for servers, workstations and NAS systems. It targets administrators who need high-capacity registered memory with error correction for 24/7 workloads. The 288-pin form factor fits DDR4 server platforms that accept LRDIMM modules. It is not compatible with standard desktop computers or with unbuffered or registered ECC memory types.
The single specification that decides fit is the 4Rx4 rank configuration combined with CL21 latency at DDR4 2933 (PC4-23400). The motherboard and memory controller must support load-reduced quad-rank modules at this speed and latency. Mixing with unbuffered or registered ECC DIMMs will prevent the system from posting. Backward compatibility with 2133, 2400 and 2666MHz buses is supported when the platform allows down-clocking.
Installation requires aligning the notch on the 288-pin edge connector with the slot key and pressing firmly until the retention clips engage. No heat spreader is present, so handle the PCB by its edges to avoid contaminating the gold contacts. The most common error is seating a module in a slot wired for registered or unbuffered memory, which causes a no-post condition. Verify the platform’s qualified vendor list for 4Rx4 LRDIMM support before purchase.
| Brand | OWC |
|---|---|
| Part Number | 2L9D44R4128G |
| Capacity | 128GB |
| Type | 288-Pin DDR4 ECC LRDIMM |
| Speed | DDR4 2933 (PC4 23400) |
| CAS Latency | CL21 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Load Reduced |
| Rank | 4Rx4 |
| Heat Spreader | No |
It adds 128GB of error-correcting capacity that runs at 2933MHz with CL21 timing, letting the system handle larger workloads and more virtual machines without paging to disk.
PC4-23400 is the JEDEC standard name for DDR4-2933; the module delivers that data rate on any platform that supports the speed, and will also run at 2133, 2400 or 2666MHz if the system requires a lower frequency.
It fits a standard 288-pin DDR4 DIMM socket; the module has no heat spreader, so it occupies only the nominal board height and works in servers, workstations or NAS systems that accept load-reduced ECC memory.
Tudi v tem oddelku
Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.
V čem plačujete in v čem berete cene.
Poslano iz Vaše denarnice ob blagajni
Samo za prikaz — katalog je cenovno izražen v dolarjih
Nobena valuta ne ustreza.
Izberite jezik, v katerem Vam govori spletna stran.
Prvič tu?
Že imate račun?
Samodejne ponastavitve ni: ta trgovina ne pošilja e-pošte, zato ni enkratne povezave, ki bi jo lahko zahtevali. Pustite naslov na računu — nekdo ga bo obravnaval ročno.
Zahteva zabeležena
V Vašo elektronsko pošto ne prihaja nič — ta trgovina ne pošilja nobene e-pošte. Zahteve nekdo obravnava ročno.
Ste se spomnili?