myVolts
myVolts TFX Power Supply 350W 420W Max Dell Liteon PS-5251-5
TFX power supply delivering 350 W continuous and 420 W peak for Dell Liteon PS-5251-5 small-form-factor desktops
- TypeAT
- Replaces Dell Liteon PS-5251-5 units directly
- Delivers 350 W continuous and 420 W peak power
- Fits slimline and SFF chassis with TFX form factor
- Runs on 100 to 240 V input worldwide
- Includes 20+4 pin, 4-pin CPU, Molex, floppy and SATA connectors
myVolts TFX 350W Replacement PSU
This myVolts TFX power supply delivers a continuous 350 W output with a 420 W peak rating. It is designed to replace the Dell Liteon PS-5251-5 unit in slimline and small-form-factor desktops. The AT-type form factor fits the same chassis cut-out as the original 200 W, 250 W, 300 W or 350 W models. Builders upgrading an aging Dell SFF system will find a direct mechanical and electrical match.
Sustained-load behaviour
The unit is rated for 350 W continuous power rather than only a short burst. An 80 mm double ball-bearing fan provides active cooling during extended workloads. Input voltage auto-ranges from 100 V to 240 V, so the supply maintains stable rails across different mains conditions. The peak capacity of 420 W handles brief transients without tripping protection circuits.
Installation notes
The cable harness includes a 20+4 pin motherboard connector, a 4-pin CPU plug, two Molex, a floppy connector and two SATA leads. Match each plug to the corresponding socket on the motherboard and drives; the keyed headers prevent mis-insertion. The TFX enclosure slides into the existing bracket and secures with the original screws. Builders needing additional SATA or PCIe connectors beyond the supplied set will require adapter cables.
I korthet
- Replaces Dell Liteon PS-5251-5 units directly
- Delivers 350 W continuous and 420 W peak power
- Fits slimline and SFF chassis with TFX form factor
- Runs on 100 to 240 V input worldwide
- Includes 20+4 pin, 4-pin CPU, Molex, floppy and SATA connectors
Specifikationer
| Type | AT |
|---|
Frågor om den här produkten
How loud is the 80 mm fan under continuous load?
The 80 mm double ball-bearing fan runs quietly at idle and increases speed only when the 350 W load demands extra airflow.
Which motherboard and CPU connectors are required for the TFX unit to power on?
The unit provides a 20+4 pin ATX motherboard connector and a 4-pin CPU connector; both must be seated for the system to start.
Will the 20+4 pin and 4-pin CPU cables reach the headers on a legacy Dell SFF board?
Cable lengths follow the TFX form factor, matching the routing of the original PS-5251-5 in Dell slimline and SFF chassis.
Även i den här avdelningen
Andra har jämfört dessa
Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.



