Vi tar emot kryptovaluta — så att kryptot du äger kan köpa riktig hårdvara.Betala med krypto, använd det till riktig hårdvara. Fri, försäkrad frakt över hela världen vid köp över 399 $. Neutrala, omärkta ytterkartonger, skickade från Tyskland.Fri, försäkrad frakt över 399 $. Din kurs låses i 30 minuter så snart kassan öppnas.Kursen låst i 30 minuter. Varje artikel är förseglad, har kontrollerat serienummer och täcks av 24 månaders garanti.Förseglad, 24 månaders garanti.

Bevakade produkter Logga in
Green 288-pin DDR4 UDIMM module with black chips, no heat spreader

NEMIX RAM

NEMIX RAM 16GB DDR4 3200 CL22 2Rx8 1.2V UDIMM for THINKMATE XF6-14X1

SKU CH-65ET-6PAHM

16 GB DDR4 3200 CL22 2Rx8 1.2 V UDIMM built for THINKMATE XF6-14X1 workstations

  • Capacity16GB
  • SpeedDDR4 3200 (PC4 25600)
  • ECCNo
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.20V
  • 16 GB DDR4-3200 boosts workstation throughput
  • CL22 latency at 1.2 V keeps power draw low
  • 2Rx8 dual-rank layout fills a single DIMM slot
  • 288-pin UDIMM fits ThinkMate XF6-14X1 without adapters
  • Major OEM chips stress-tested for enterprise stability

NEMIX RAM 16GB DDR4 3200 for Thinkmate XF6-14X1

This NEMIX RAM module provides 16GB of DDR4 3200 memory in a single 288-pin UDIMM. It runs at 1.20V with CL22 latency and a 2Rx8 rank configuration. The memory uses major OEM chips from Samsung, Micron or Hynix and is validated for the Thinkmate XF6-14X1 workstation. No heat spreader is included.

Who this suits and who should look elsewhere

This module suits owners of a Thinkmate XF6-14X1 workstation needing a 16GB DDR4 3200 upgrade. It is non-ECC and unbuffered so it will not work in systems that require registered or ECC memory. Buyers who need error-correcting code support or registered DIMMs should look elsewhere.

What the package contents change

The package contains one 16GB UDIMM and nothing else. No software, cables or additional accessories are bundled. The memory arrives ready to install in a compatible motherboard slot.

I korthet

  • 16 GB DDR4-3200 boosts workstation throughput
  • CL22 latency at 1.2 V keeps power draw low
  • 2Rx8 dual-rank layout fills a single DIMM slot
  • 288-pin UDIMM fits ThinkMate XF6-14X1 without adapters
  • Major OEM chips stress-tested for enterprise stability

Specifikationer

BrandNEMIX RAM
SeriesTHINKMATE Server/Workstation Compatible Series Memory
ModelTHINKMATE DDR4 3200MHZ Non-ECC Unbuffered UDIMM
Part NumberMD25600-628K1
Capacity16GB
SpeedDDR4 3200 (PC4 25600)
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.20V
Compatible SystemTHINKMATE
CAS LatencyCL22
Heat SpreaderNo
Type288-Pin DDR4 UDIMM
Rank2Rx8
FeaturesDDR4 Non- ECC Unbuffered UDIMM Motherboard Compatible
Package Content16GB (1X16GB) DDR4 3200MHZ PC4-25600 2Rx8 1.2V CL22 288-PIN Non-ECC Unbuffered UDIMM

Frågor om den här produkten

Does my THINKMATE XF6-14X1 need a free 288-pin DDR4 UDIMM slot to accept this 16GB module?

Yes, the module uses the standard 288-pin DDR4 UDIMM form factor, so an available DDR4 UDIMM slot on the XF6-14X1 motherboard is required for installation.

Will this 3200 MHz CL22 2Rx8 module run at its rated speed if I keep slower DDR4 sticks in the other slots?

The system will typically downclock all modules to the speed of the slowest installed stick, so this 3200 MHz module would run at the lower frequency of the older modules.

How can I confirm the module is recognised at 3200 MHz with CL22 timings after I install it?

Check the memory speed and CAS latency in the BIOS setup or use a tool such as CPU-Z to verify the module reports 3200 MHz and CL22 timings.

Även i den här avdelningen

Andra har jämfört dessa

Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.