Computer Memory Solutions
Computer Memory Solutions 2GB DDR2 667 SODIMM for HP/Compaq Presario Cq60-125Eo Es Et memory upgrade
2 GB DDR2 667 MHz SO-DIMM memory upgrade for HP/Compaq Presario CQ60-125 models
- Capacity2GB
- Type200-Pin DDR2 SO-DIMM
- SpeedDDR2 667 (PC2 5300)
- CAS LatencyCL5
- Timing5-5-5
- Voltage1.8V
- 2GB capacity adds headroom for everyday multitasking
- DDR2 667 speed matches the laptop's memory bus
- 200-pin SO-DIMM form factor fits the Presario CQ60 slots
- CL5 timing keeps latency low for responsive performance
- 8 V operation matches the system's standard voltage
Targeted HP Presario Upgrade
This 2GB DDR2 SODIMM is built to match the HP/Compaq Presario Cq60-125Eo, Cq60-125Es and Cq60-125Et notebooks. It runs at 667 MHz with CL5 timing and 1.8V unbuffered operation. The 200-pin form factor fits the factory memory slots directly. Computer Memory Solutions validates compatibility for these specific models.
Scope of Fit
The module suits owners of the listed Presario Cq60 variants who need a single 2GB stick to reach the 4GB system maximum across two sockets. It will not help buyers who want more storage or a faster memory standard than DDR2. Systems outside the named compatibility list should look at something else because validation is limited to these units.
Straightforward Installation
Installation follows the usual SODIMM process: power off, open the memory door, align the notch on the 200-pin edge connector and press until the latches click. No heat spreader is fitted, so clearance is rarely an issue. The most common problem is seating the stick fully; a firm, even push on both ends avoids a partial contact that can prevent boot.
จุดเด่น
- 2GB capacity adds headroom for everyday multitasking
- DDR2 667 speed matches the laptop's memory bus
- 200-pin SO-DIMM form factor fits the Presario CQ60 slots
- CL5 timing keeps latency low for responsive performance
- 8 V operation matches the system's standard voltage
ข้อมูลจำเพาะ
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM256645300SO |
| Capacity | 2GB |
| Type | 200-Pin DDR2 SO-DIMM |
| Speed | DDR2 667 (PC2 5300) |
| CAS Latency | CL5 |
| Timing | 5-5-5 |
| Voltage | 1.8V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Hp/Compaq Presario Cq60-125Eo, Cq60-125Es, Cq60-125Et |
| Package Content | 1 Memory RAM Stick |
คำถามเกี่ยวกับสินค้านี้
Does my HP/Compaq Presario CQ60-125EO need an empty 200-pin SODIMM slot to accept this 2GB DDR2 667 module?
Yes, the laptop has two SODIMM sockets and supports up to 4GB total, so one free 200-pin slot is required for this stick.
Can I keep an existing PC2-5300 stick in the second slot while adding this CM256645300SO module?
Both modules run at DDR2 667 with CL5 timing and 1.8V, so they will operate together at the same speed and voltage.
How can I verify the new memory is recognised at the correct 667 MHz speed after installation?
Check the BIOS memory information or use a system utility such as CPU-Z to confirm the module reports DDR2-667 and 2GB capacity.
อื่น ๆ ในหมวดนี้
ลูกค้ามักเปรียบเทียบสินค้าเหล่านี้
หมวดเดียวกัน การชำระเงินแบบเดียวกัน — แปดสกุลเงินคริปโตและอัตราแลกเปลี่ยนที่ล็อกไว้ 30 นาที



