Computer Memory Solutions
Computer Memory Solutions 32GB (2x16GB) DDR4 2400 CL17 DIMM C114
A 32 GB DDR4 kit of two 16 GB DIMMs at 2400 MHz CL17 for ASRock A320M, B250, B350 and B450 boards
- Capacity32GB (2 x 16GB)
- Type288-Pin DDR4 SDRAM
- SpeedDDR4 2400 (PC4 19200)
- CAS LatencyCL17
- Timing17-17-17
- Voltage1.2V
- 32 GB kit upgrades compatible ASRock boards to 64 GB max
- 2400 MHz DDR4 modules run at 1.2 V for efficient power use
- CL17 17-17-17 timing delivers responsive desktop performance
- Unbuffered non-ECC 288-pin DIMMs install directly in four slots
- Two 16 GB sticks from CMS validated for listed motherboard models
Targeted System Memory
This 32GB kit contains two 16GB DDR4 DIMMs validated for specific ASRock motherboards. It is built for owners of the listed A320M Pro4, AB350 Pro4, AB350M Pro4, B250 Pro4, B250M Pro4, B450 Pro4 and B450M Pro4 boards who need a matched pair. Builders using other platforms should verify support before purchasing.
Physical Design and Installation
Each module uses a standard 288-pin unbuffered layout without a heat spreader, keeping the profile low for tight CPU cooler clearances. The 1.2V operating voltage matches the DDR4 baseline for these boards. Installing the pair fills two of the four available slots, leaving room to reach the 64GB maximum capacity later.
DDR4 2400 Performance Boundary
The kit runs at DDR4 2400 with CL17 17-17-17 timings, delivering PC4 19200 bandwidth on compatible systems. Boards limited to lower memory speeds will downclock the modules automatically. The 64GB ceiling across four slots means this 32GB kit cannot be expanded beyond two additional sticks of similar specification.
จุดเด่น
- 32 GB kit upgrades compatible ASRock boards to 64 GB max
- 2400 MHz DDR4 modules run at 1.2 V for efficient power use
- CL17 17-17-17 timing delivers responsive desktop performance
- Unbuffered non-ECC 288-pin DIMMs install directly in four slots
- Two 16 GB sticks from CMS validated for listed motherboard models
ข้อมูลจำเพาะ
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM2048642400DIMM |
| Capacity | 32GB (2 x 16GB) |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Timing | 17-17-17 |
| Voltage | 1.2V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | ASRock A320M Pro4, AB350 Pro4, AB350M Pro4, B250 Pro4, B250M Pro4, B450 Pro4, B450M Pro4 Motherboards |
| Package Content | 2 Memory RAM Sticks |
คำถามเกี่ยวกับสินค้านี้
Does this DDR4 2400 CL17 kit run at the full 2400 MT/s on the listed ASRock boards?
The modules are rated DDR4 2400 (PC4 19200) with CL17 17-17-17 timing at 1.2 V. On the compatible ASRock A320M Pro4, AB350 Pro4, AB350M Pro4, B250 Pro4, B250M Pro4, B450 Pro4 and B450M Pro4 boards they will operate at up to 2400 MT/s, subject to the motherboard's memory controller and BIOS settings.
What physical clearance do the 288-pin DIMMs need inside the case?
Each stick is a standard 288-pin unbuffered DIMM without a heat spreader, so only the usual DIMM slot height and the motherboard's CPU-cooler clearance apply. No extra length or width beyond the JEDEC form factor is required.
Which slot pair should I populate first on a four-slot board, and what mistake do builders make?
On the four-slot ASRock boards listed, install the two 16 GB modules in the same-coloured slots (usually slots 2 and 4) to run dual-channel. The common error is placing them in adjacent slots 1 and 2, which forces single-channel operation.
อื่น ๆ ในหมวดนี้
ลูกค้ามักเปรียบเทียบสินค้าเหล่านี้
หมวดเดียวกัน การชำระเงินแบบเดียวกัน — แปดสกุลเงินคริปโตและอัตราแลกเปลี่ยนที่ล็อกไว้ 30 นาที



