KHACHIMO
KHACHIMO H47107 400W ATX 80 PLUS Gold power supply
An 80 PLUS Gold ATX unit delivering 400 W with zero-RPM fan mode and Modern Standby support for silent, efficient operation
- TypeATX
- Fast wake-from-sleep with Modern Standby support
- 80 PLUS Gold efficiency cuts power draw and heat
- Zero RPM fan mode stops fan at low loads
- Resonant LLC topology with DC-to-DC for stable output
- 400 W ATX power for standard desktop builds
400W ATX power supply for efficient builds
This KHACHIMO H47107 unit delivers 400 watts of continuous power in a standard ATX form factor. It targets system builders who want reliable energy delivery without excess capacity. The 80 PLUS Gold rating confirms high efficiency across typical loads, reducing waste heat and electricity draw.
Upgrade from lower-efficiency or noisy units
Replacing an older Bronze-rated or uncertified supply cuts power loss and enables Modern Standby for faster wake times. The jump is worthwhile when your current unit lacks DC-to-DC conversion or runs its fan constantly at idle. Builders staying within a 400 W envelope gain cleaner rails and quieter operation without over-provisioning.
Fits standard ATX cases
The resonant LLC topology with DC-to-DC conversion provides stable voltages for modern sleep states, so the board and firmware must support those states to benefit. Zero RPM mode keeps the fan off at low and medium loads, freeing acoustic headroom for GPU or CPU coolers. Ensure your case accepts a regular ATX power supply and that your component peak draw stays within the rated output.
จุดเด่น
- Fast wake-from-sleep with Modern Standby support
- 80 PLUS Gold efficiency cuts power draw and heat
- Zero RPM fan mode stops fan at low loads
- Resonant LLC topology with DC-to-DC for stable output
- 400 W ATX power for standard desktop builds
ข้อมูลจำเพาะ
| Type | ATX |
|---|
คำถามเกี่ยวกับสินค้านี้
What ATX case clearance does the H47107 400W PSU require?
The unit follows the standard ATX form factor, so any case with a regular ATX power-supply bay will accept it without modification.
Which cables must be connected during installation to enable Modern Standby?
Attach the 24-pin motherboard connector and the 4+4-pin CPU power cable; the PSU then supports the low-power sleep states automatically.
How do I clean the fan on the H47107 after extended use?
Power off the system, remove the PSU, and blow compressed air through the fan grille to clear dust from the Zero RPM fan assembly.
อื่น ๆ ในหมวดนี้
ลูกค้ามักเปรียบเทียบสินค้าเหล่านี้
หมวดเดียวกัน การชำระเงินแบบเดียวกัน — แปดสกุลเงินคริปโตและอัตราแลกเปลี่ยนที่ล็อกไว้ 30 นาที



