NEMIX RAM
NEMIX RAM 64GB (2x32GB) DDR5 5600 ECC Unbuffered UDIMM CL46 1.1V 288-Pin Kit for SuperMicro BH4SR2-25G BH4SRG
A 64 GB DDR5 ECC unbuffered kit of two 32 GB modules running at 5600 MT/s with CL46 latency and 1.1 V for SuperMicro BH4SR2-25G and BH4SRG motherboards
- Capacity64GB (2 x 32GB)
- SpeedDDR5 5600 (PC5 44800)
- ECCYes
- Buffered/RegisteredUnbuffered
- ChipsetMajor OEM Samsung, Micron, Hynix
- Voltage1.10V
- ECC protection guards data integrity for critical workloads
- 5600 MHz DDR5 speed accelerates memory-intensive tasks
- 64 GB kit doubles capacity with two 32 GB modules
- Low 1.1 V operation reduces power draw and heat
- Validated for SuperMicro BH4SR2-25G and BH4SRG motherboards
Capacity and Compatibility
This 64GB kit delivers two 32GB DDR5 5600 ECC unbuffered UDIMMs built for SuperMicro BH4SR2-25G and BH4SRG motherboards. The modules run at 1.1V with CL46 latency and use a 2Rx8 organisation on a standard 288-pin interface. They provide error-correcting memory for workloads that require data integrity.
Suitability and Limits
Builders upgrading or repairing the listed SuperMicro platforms can install this kit directly. Systems that need registered DIMMs, non-ECC memory, or a different DDR generation will not accept these modules. The 32GB per module density also means boards limited to lower single-DIMM capacities cannot use the kit.
Deciding Specification
The key figure is the DDR5 5600 (PC5-44800) ECC unbuffered UDIMM standard at 1.1V with CL46 timing. Match this exact specification against the motherboard memory QVL before purchase to confirm compatibility.
จุดเด่น
- ECC protection guards data integrity for critical workloads
- 5600 MHz DDR5 speed accelerates memory-intensive tasks
- 64 GB kit doubles capacity with two 32 GB modules
- Low 1.1 V operation reduces power draw and heat
- Validated for SuperMicro BH4SR2-25G and BH4SRG motherboards
ข้อมูลจำเพาะ
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM Original Series Memory |
| Model | DDR5 ECC Unbuffered UDIMM Memory |
| Part Number | ME44800-328K2 |
| Capacity | 64GB (2 x 32GB) |
| Speed | DDR5 5600 (PC5 44800) |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Voltage | 1.10V |
| Compatible System | Supermicro |
| CAS Latency | CL46 |
| Heat Spreader | No |
| Type | 288-Pin DDR5 ECC UDIMM |
| Rank | 2Rx8 |
| Features | DDR5 ECC Unbuffered UDIMM Motherboard Compatible |
| Package Content | 64GB (2 x 32GB) DDR5 5600MHz PC5-44800 2Rx8 1.1V 288-PIN ECC UDIMM KIT |
คำถามเกี่ยวกับสินค้านี้
Does my SuperMicro BH4SR2-25G or BH4SRG motherboard need to support DDR5 5600 ECC unbuffered UDIMMs for this kit to work?
Yes, the motherboard must accept DDR5 5600 ECC unbuffered UDIMMs at 1.1V with 288-pin layout; the kit is validated for those exact SuperMicro models.
Will the CL46 2Rx8 modules run at their rated 5600 speed if the board only officially supports a lower DDR5 data rate?
The modules will operate at the highest speed the motherboard allows; if the board caps DDR5 below 5600, they will downclock automatically while keeping ECC and 1.1V operation.
How can I confirm the kit is running as intended after installation?
Check BIOS or OS memory reporting for 64 GB total, DDR5 5600 (PC5-44800), CL46 timings, ECC active, and 1.1V voltage on both 2Rx8 modules.
อื่น ๆ ในหมวดนี้
ลูกค้ามักเปรียบเทียบสินค้าเหล่านี้
หมวดเดียวกัน การชำระเงินแบบเดียวกัน — แปดสกุลเงินคริปโตและอัตราแลกเปลี่ยนที่ล็อกไว้ 30 นาที



