NEMIX RAM 64GB DDR5 5600 CL46 2Rx4 1.1V ECC Registered RDIMM memory upgrade

Exact-match server upgrade

This 64 GB DDR5 5600 registered ECC RDIMM is built for administrators expanding a GIGABYTE MZ33-AR1 system. The 2Rx4 organisation, 1.10 V operating voltage and CL46 timing match the board's memory-controller expectations so every slot can run fully populated at rated speed. Enterprise workloads benefit from the registered buffer that offloads the controller and on-die ECC that corrects single-bit errors before they reach production data.

Check board population rules

Verify the motherboard manual for supported capacities per slot, approved DIMM population order and any BIOS revision requirements before ordering. The module uses the 288-pin RDIMM form factor required by this platform; UDIMM or SODIMM variants will not fit or function. Confirm that your chassis airflow can accommodate the bare-module design which has no integrated heat spreader.

Thermals noise and power

Registered architecture and the low 1.10 V voltage keep per-module power draw modest under typical server loads. With no heat spreader or active cooling on the DIMM itself, temperatures depend entirely on case airflow directed across the memory slots. Acoustic output is silent as there are no moving parts on the module.