Enfain
Enfain OM3 LC-FC Duplex Multimode Fibre Optic Cable 25m
A 25-metre OM3 duplex multimode patch cord with LC and FC connectors, 3.0 mm jacket, 850 nm wavelength, 0.2 dB typical insertion loss and >38 dB return loss
- Supports 10/40G speeds with OM3 850nm core
- Low 0.2dB typical insertion loss preserves signal quality
- High >38dB return loss minimises back-reflection
- Durable 3.0mm PVC jacket rated for 1000 mating cycles
- Operates reliably from -20°C to +60°C
Enfain OM3 Duplex Patch Cable
This 25 metre OM3 multimode cable carries 10 gigabit signals over an 850 nm wavelength. It uses a duplex LC to FC connector pair with a 3.0 mm PVC jacket and ceramic ferrules. Typical insertion loss is .2 dB and maximum insertion loss is .3 dB while return loss exceeds 38 dB.
Suited for short reach data centre links
The cable suits server, switch and storage connections inside a rack or between adjacent racks. It supports 1G, 10G and 40G multimode standards. Builders who need single mode reach, longer distances or a different connector combination should choose another cable.
Fits standard LC and FC transceiver ports
The 330 mm minimum bending radius allows tidy routing in dense patch panels. Ceramic ferrules withstand 1000 mating cycles and the assembly operates from -20 °C to +60 °C. The aqua jacket identifies OM3 grade fibre at a glance.
Öne çıkanlar
- Supports 10/40G speeds with OM3 850nm core
- Low 0.2dB typical insertion loss preserves signal quality
- High >38dB return loss minimises back-reflection
- Durable 3.0mm PVC jacket rated for 1000 mating cycles
- Operates reliably from -20°C to +60°C
Teknik özellikler
Bu ürün için henüz yayınlanmış teknik özellik yok.
Bu modelin diğer sürümleri
Aynı seriden 5 tane daha
Aynı aile, farklı bellek, soğutucu veya frekans — karar vermeden önce karşılaştırın.
Bu ürünle ilgili sorular
What connectors must my switch and server already have to use this LC-FC duplex cable?
One end needs an LC port and the other an FC port; both must support multimode fibre at 850 nm.
Will this OM3 patch cord still reach 10 Gbps if I keep my older 1 Gbps transceivers?
Yes, the cable is rated for 1 G, 10 G and 40 G operation, so legacy 1 G transceivers will work.
How can I verify the link is healthy after I plug it in?
Measure insertion loss with a light source and power meter; typical loss should be around .2 dB and not exceed .3 dB, while return loss should be better than 38 dB.
Bu reyondan diğerleri
Müşteriler bunları karşılaştırdı
Aynı raf, aynı sipariş tamamlama — sekiz koin ve 30 dakikalık kur kilidi.
Black Box Corporation DisplayPort to DVI Fibre Optic Cable 15 ft 4.5 m 1.35 GB/s
- Consumer Electronics








