OWC 16GB DDR4 3200MHz CL22 1.2V 260pin SODIMM Alienware X17 R1
- 16GB
- 260-Pin DDR4 Non-EC…
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
Brute Networks
16 GB DDR4-2666 ECC registered RDIMM with CL15 latency and 1.2 V operation for Dell-compatible servers
This 16GB DDR4-2666 registered DIMM is built for Dell servers that require ECC memory. It targets administrators expanding capacity in existing rack or tower systems without replacing the platform. The module uses major-brand DRAM and matches Dell part number AA138422 for drop-in installation.
The single specification that determines fit is the registered ECC design with 2Rx8 rank structure at CL15 latency. Only systems that accept 288-pin DDR4 RDIMMs at 1.2V and PC4-21300 speed can use this module. Unbuffered or non-ECC platforms will not recognize it.
Brute Networks backs the module with a lifetime warranty, so a failed stick can be replaced without purchasing new hardware. The 100% Dell-compatible validation means the existing service contract remains intact after installation. No additional software or cables are included in the package.
| Brand | Dell |
|---|---|
| Capacity | 16GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2666 (PC4 21300) |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
The module will run at up to 2666 MT/s when the platform supports that speed; otherwise it downclocks to the highest speed the memory controller allows.
The 288-pin DDR4 interface caps the data rate at 2666 MT/s with CL15 latency and 1.2 V operation, so bandwidth and timing are fixed by this standard.
It requires a standard 288-pin DDR4 DIMM socket; the registered design adds a buffer chip, so verify the motherboard supports registered modules and that heatsink clearance is adequate.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟