نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.

قائمة الرصد تسجيل الدخول
Two green DDR5 RDIMM modules with black chips, no heat spreader

NEMIX RAM

NEMIX RAM DDR5 4800 64GB (2x32GB) ECC RDIMM CL40 1.1V Supermicro H13SVW-NT memory upgrade

SKU CH-XWA0-BNE41

64 GB dual-channel DDR5 kit with ECC and registered buffering for the Supermicro H13SVW-NT motherboard

  • Capacity64GB (2 x 32GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 64GB 2X32GB

عرض 12 تكوينات إضافية

Speed 4800MHz

  • 64 GB capacity in a matched 2×32 GB kit for full server performance
  • DDR5-4800 speed with CL40 latency delivers rated bandwidth without tuning
  • ECC and registered design correct single-bit errors and stabilise fully populated slots
  • 1 V operation at 288-pin RDIMM form factor matches the motherboard's electrical spec
  • Validated for Supermicro H13SVW-NT so the kit is recognised at full capacity

Server-grade DDR5 64GB kit

This 64GB kit contains two 32GB DDR5 4800 Registered ECC RDIMMs built for the Supermicro H13SVW-NT motherboard. The 2Rx8 modules run at 1.10V with CL40 timing and match the exact rank, voltage and timing the board's memory controller expects. System integrators upgrading compatible Supermicro platforms receive a verified fit that populates every slot at rated speed. Buyers needing unbuffered UDIMMs or laptop SODIMMs cannot use these modules.

Sustained-load stability

Registered architecture buffers the command and address signals so the memory controller stays within its electrical limits even when all channels are fully populated. ECC circuitry detects and corrects single-bit errors on the fly, preventing silent data corruption during long compute runs. The 1.10V operating voltage keeps power draw predictable under continuous server workloads. Workloads that demand higher frequencies or lower latencies than DDR5 4800 CL40 will not be satisfied by this kit.

DDR5 4800 interface limits

The PC5-38400 standard caps transfer rate at 4800 MT/s, so bandwidth scales with channel count rather than per-module speed. Four 288-pin RDIMM slots on the target board set the physical ceiling for this kit's capacity. Mixing ranks or voltages beyond the board's qualified vendor list breaks the memory-training sequence at boot. Systems requiring speeds above 4800 MT/s or capacities beyond the motherboard's validated maximum must choose a different memory specification.

أبرز المميزات

  • 64 GB capacity in a matched 2×32 GB kit for full server performance
  • DDR5-4800 speed with CL40 latency delivers rated bandwidth without tuning
  • ECC and registered design correct single-bit errors and stabilise fully populated slots
  • 1 V operation at 288-pin RDIMM form factor matches the motherboard's electrical spec
  • Validated for Supermicro H13SVW-NT so the kit is recognised at full capacity

المواصفات

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-328K2
Capacity64GB (2 x 32GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content64GB 2X32GB DDR5 4800MHz PC5-38400 2Rx8 1.1V 288-PIN ECC RDIMM KIT

إصدارات أخرى من هذا الطراز

5 أخرى من الفئة نفسها

نفس الفئة، بذاكرة أو مبرّد أو تردد مختلف — قارن قبل أن تقرر.

أسئلة حول هذا المنتج

How much power does the 1.1V DDR5 4800 kit draw when the server runs continuously?

Each module operates at 1.10V DDR5 standard voltage. Registered architecture reduces electrical load on the memory controller, helping keep system power draw predictable during all-day workloads.

What motherboard slot and population rules must my Supermicro H13SVW-NT already follow for this 2Rx8 RDIMM kit?

The board requires 288-pin DDR5 RDIMM slots. Install the pair in the sequence the manual specifies for 2Rx8 registered DIMMs so the memory controller recognises the full 64GB at rated speed.

Will the 288-pin DDR5 registered ECC modules work in the same chassis as older DDR5 RDIMMs I may keep?

Yes, if the remaining slots accept DDR5 288-pin RDIMMs. Match speed, voltage, rank and ECC type per the motherboard population rules; mixed ranks or voltages can prevent the full 64GB from being recognised.

أيضًا في هذا القسم

عملاء قارنوا هذه المنتجات

نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.