OEM Industries
OEM Industries FFB0612EHE 60mm 2 Ball 12V 1.20A CPU cooler
A 60 mm dual ball-bearing fan delivering 8000 RPM and 50.15 CFM airflow at 12 V and 1.20 A
- ColorBlack
- TypeFan only
- Fan Size60mm
- Bearing Type2 Ball
- Power Connector3 Pin
- LEDNo
- High airflow of 50.15 CFM for effective cooling
- Dual ball bearing design extends operational lifespan
- 12 V DC power with 1.20 A current draw
- 8000 RPM speed delivers strong static pressure
- 60 mm compact frame fits tight chassis spaces
60mm dual-ball bearing fan
The OEM Industries FFB0612EHE is a 60mm DC fan built with a dual ball bearing for extended service life. It runs on 12V and draws 1.20A, delivering 50.15CFM at 8000RPM. The unit is a fan-only component supplied in new condition.
Compact builds and high-RPM replacement
This cooler suits small-form-factor systems or legacy heatsinks that require a 60mm frame and high static pressure. The three-pin connector provides basic speed reporting without PWM control. Buyers needing a larger frame, lower noise profile or four-pin PWM regulation should look elsewhere.
Straightforward three-pin mounting
Installation uses standard 60mm mounting holes and a single three-pin header on the motherboard or fan controller. No additional wiring or adapters are included. The high rotational speed can produce noticeable noise, so verify case airflow and acoustic targets before fitting.
أبرز المميزات
- High airflow of 50.15 CFM for effective cooling
- Dual ball bearing design extends operational lifespan
- 12 V DC power with 1.20 A current draw
- 8000 RPM speed delivers strong static pressure
- 60 mm compact frame fits tight chassis spaces
المواصفات
| Model | FFB0612EHE |
|---|---|
| Color | Black |
| Type | Fan only |
| Fan Size | 60mm |
| Bearing Type | 2 Ball |
| Power Connector | 3 Pin |
| LED | No |
أسئلة حول هذا المنتج
What motherboard header do I need for the 3-pin power connector on this fan?
A standard 3-pin or 4-pin fan header supplies the 12V power and tachometer signal required by the 3-pin connector.
Will the 60mm frame and 14.4W draw fit the mounting holes and power budget of my legacy socket cooler?
The 60mm square frame matches common 6038 mounting patterns, and the 1.20A draw at 12V fits most older board headers rated for 1A or higher.
How can I verify the fan is spinning at the rated 8000 RPM and moving 50.15 CFM after installation?
Check the RPM reading in BIOS or monitoring software; it should report close to 8000 RPM, and airflow will feel strong at the exhaust.
أيضًا في هذا القسم
عملاء قارنوا هذه المنتجات
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ModMyMods MOD-0002 3/8" ID x 1/2" OD Clear PVC Tubing DIY Cooling
- Clear



